Bedienungsanleitung Quadra-Fire Classic Bay 1200 - Pellet

815525

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

20 04/217027-805J

Figure 20.1

Cleaning Rods

Heat Exchanger Tubes

NOTE:

Hearth & Home Technologies recommends to use

a heavy duty vacuum cleaners specically designed for

solid fuel appliance cleaning.

8. Cleaning Exhaust Path

• Frequency: Yearly or more frequently depending on ash

build-up.

• By: Homeowner

a. Be sure the appliance is allowed to cool, has been

unplugged and the exhaust blower is o󰀨.

b. Open the hinged access door on the left of the insert.

c. Reach in and unlatch the trap door that is connected

to the rear of exhaust blower.

d. Use a small vacuum hose attachment to clean area.

e. Re-latch and close trap door.

9. Cleaning the Hopper

• Frequency: Monthly or every 1 ton of fuel

• By: Homeowner

After burning approximately 1 ton of fuel you will need to

clean the hopper to prevent sawdust build-up. A combination

of sawdust and pellets on the auger reduces the amount

of fuel supply to the re pot. This can result in nuisance

shutdowns and mis-starts.

a. The appliance must be in complete shutdown. Allow

the appliance to completely cool down.

b. Empty the hopper of any remaining pellets.

c. Vacuum the hopper and feed tube.

7. Cleaning Beneath Heat Exchanger

• Frequency: Monthly or every 1 ton of fuel

• By: Homeowner

a. Be sure the appliance is allowed to cool, has been

unplugged and the exhaust blower is o󰀨.

b. A more thorough cleaning is needed to remove the

excess ash that is left behind from the use of the

cleaning rods for the heat exchanger tubes.

c. The ash will be resting on the back of the ba󰀪e. This

will require removing the ba󰀪e and cast brick set.

Please refer to Ba󰀪es on page 27.

6. Cleaning Heat Exchanger Chambers & Drop Tube

• Frequency: Weekly or every 1 ton of fuel

• By: Homeowner

he amount of ash buildup in the rebox will be a good

guide to determine how often you should clean the

heat exchangers.

a. Allow the appliance to completely cool down before

pulling the cleaning rods. Turn the thermostat on and

then immediately o󰀨 to start the exhaust blower on its

cycle time. It will pull y ash out the exhaust instead

of into the room.

b. To access the cleaning rods lift the hopper lid. Both

bent handle pull rods are located close to the face of

the appliance to the left and right side (Figure 20.1).

c. To clean, pull the rods straight out until it stops,

approximately 8 inches (203mm). Slide the rods OUT

and IN a couple of times.

5. Disposal of Ashes

• Frequency: As needed

• By: Homeowner

Ashes should be placed in a metal container with a tight-

tting lid. The container of ashes should be moved outdoors

immediately and placed on a non-combustible oor or

on the ground, well away from all combustible materials,

pending nal disposal.

If the ashes are disposed of by burial in soil or otherwise

locally dispersed, they should be retained in the closed

container until all cinders have been thoroughly cooled.

Disposal of Ashes.

• Ashes should be placed in metal container

with tight tting lid.

• Ashes should be retained in closed

container until all cinders have

thoroughly cooled.

WARNING

Heat exchanger cleaning rods may be warm

to the touch. For safety purposes wear

gloves.

Do not pull heat exchanger cleaning rods

while appliance is operating.

Push cleaning rods IN when done, DO NOT

leave cleaning rods OUT. Injury can occur.

WARNING

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Quadra-Fire Classic Bay 1200 - Pellet - Insert Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Quadra-Fire Classic Bay 1200 - Pellet - Insert

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info