Bedienungsanleitung Reebok T 6.80 TREADMILL (Seite 14 von 32) (Englisch)

559723

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

HOW TO TURNON THE POWER

IMPORTANT: If the treadmill has been exposed to

old temperatures, allow it to warm to room tem-

perature before turning on the power. If you do not

o this, the console displays or other electrical

components may become damaged.

Plug in the power cord (see

page 12). Next, locate the

reset/off circuit breaker on

the treadmill frame near the

power cord. Switch the cir-

cuit breaker to the reset po-

sition.

IMPORTANT: The console features a display demo

mode, designed to be used if the treadmill is dis-

played in a store. If the displays light as soon as

you plug in the power cord and switch the circuit

breaker to the reset position, the demo mode is

turned on. To turn off the demo mode, hold down

the Stop button for a few seconds. If the displays

remain lit, see THE INFORMATION MODE on page

18 to turn off the demo mode.

Next,stand on the foot rails of the treadmill. Find the

clip attached to the key (see the drawing on page 13)

and slide the clip onto the waistband of your clothes.

Then, insert the key into the console. After a moment,

the displays will light. IMPORTANT: In an emergency

situation, the key can be pulled from the console,

causing the walking belt to slow to a stop. Test the

clip by carefully taking a few steps backward; if the

key is not pulled from the console, adjust the posi-

tion of the clip.

HOW TO USE THE MANUAL MODE

1. Insert the key into the console.

See HOW TO TURN ON THE POWER to the left.

2. Select the manual mode.

When the key is in-

serted, the manual

mode will be se-

lected. If a classic

workout or the

weight loss center

has been selected, remove the key and then rein-

sert it.

3. Startthe walking belt.

To start the walking belt, press the Start button, the

Speed increase button, or one of the speed buttons

numbered 1 through 10.

If you press the Start button or the Speed increase

button, the walking belt willbegin to moveat 1mph.

As you exercise, change the speed of the walking

belt as desired by pressing the Speed increase and

decrease buttons. Each time you press a button,

the speed setting will change by 0.1 mph; if you

hold down a button, the speed setting will change

in increments of0.5 mph.Note:Afteryoupressa

button,it may takea momentforthe walking beltto

reachtheselectedspeedsetting.

Ifyou press oneof the numberedspeedbuttons, the

walking beltwillgraduallyincreasein speed until it

reaches theselectedspeed setting.

To stop the walking belt, press the Stop button. To

restart thewalkingbelt,press theStartbutton or the

Speed increase button.

4. Change the incline of the treadmill as desired.

To change the incline of the treadmill, press the

Incline increase or decrease buttons. Each time

you press the Incline increase or decrease button,

the incline will change by 0.5%. Note: After you

pressan Incline button, it may take a moment for

the treadmill to reach the selected incline setting.

Reset

Position

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Reebok T 6.80 TREADMILL Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info