Bedienungsanleitung Robomow MS2500 (Seite 50 von 62) (Englisch)

644646

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

Robomow S models

Message

Displayed

Probable Cause/Event Corrective/User Action

Recharge battery

- The maximum operating time has been

reached (displayed in non-Base Station zone).

- Mower is searching for the Base Station but

the battery voltage is too low to continue the

searching process.

- Connect the charger to the mower or place it in the Base

Station for charging.

- Drive the mower manually using the remote control or

carry it by hand for charging in the Base Station.

Start elsewhere

- Drive wheel motors have been working under

a severe load during automatic or manual

operation.

- Check to insure the mower is not stuck, allowing the

drive wheels to slip.

- Check the ground around the mower for holes or

indentations. Fill with dirt and level off.

- Check if the drive wheels are free to rotate and nothing

blocks them.

- Remove the mower away from this particular location

and restart operation.

Start inside

- Automatic operation is initiated while the robot

is placed out of the Perimeter Wire loop.

- Place the mower inside the lawn and press the

button.

- Swap wires in the plot connector.

Stuck in place

- Robomow got stuck in place. It cannot continue

driving.

- Check the ground for holes or indentations, where the

mower has stopped and fill it with dirt and level off –

especially in the area close to the perimeter, where the

Robomow turns in place.

- Robomow has difficulty to turn in place

because the front wheel is blocked by a hole

or indentation. It caused the mower to turn in

place without detecting wire or bumper.

- Verify that the area is not too steep.

- Work mainly in dry conditions.

- Check if the Perimeter Wire is not too close to the edge

– move if required.

- Verify that the mowing deck is not set too low.

Sub-Zone X

Problem

- Sub-Zone 1/2/3/4 entry problem.

- The mower either fails to leave / bypass the

Base Station on its way to the Sub-Zone, or

fails to enter the Sub-Zone.

- The mower will try to reach the Sub-Zone every

two hours. If the mower fails to reach the Sub-

Zone within three attempts, it will stay in the

Base Station until the end of current mowing

cycle. It will not skip to the next Sub-Zone (if

there are any), if it fails to reach the current one.

- Try to start manual mowing (refer to section 4.5 –

Manual Operation). Check if something disturbs

mower’s driving backwards and/or bypassing the Base

Station. Confirm the mower drives along the perimeter

wire and doesn’t fall off the lawn’s edge, when it departs

from the Base Station.

- Confirm that the mower is able to follow the perimeter

wire along the narrow pass until it reaches the Sub-

Zone. Refer to section 2.2.2 for instructions on how to

set a narrow pass properly.

Switch off

before lifting

- The user carries Robomow manually while the

Safety Switch is On.

- Switch Off the Safety Switch before carrying Robomow.

Waiting for

Signal…

- Robomow has stopped the operation: it does

not detect a signal.

- Check the power to the Power Box.

- It may be an electrical power interruption. There is no

need to do anything. Robomow will renew operation as

soon as power is back.

- תועמשמשיםא,ךרוצןיאםא –

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Robomow MS2500 Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Robomow MS2500

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info