Bedienungsanleitung Roland BK-9 Tone Drum Kit List (Seite 53 von 64) (Englisch, Holländisch)

527395

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

MFX types and parameters

note-value of a tempo if you set the “Sync” parameter above to

“Note”. Specify the value of the desired note.

z Depth (0~127) —Depth to which the eect is applied.

z EQ Low Gain (–15dB~0~15dB) —Gain of the low frequency

range.

z EQ High Gain (–15dB~0~15dB) —Gain of the high frequency

range.

z Level (0~127) —Output level.

55. Step Pan

This uses a 16-step sequence to vary the panning of the sound.

z Step 1~16 (L64~0~63R) —Pan at each step.

z Rate [sync] (Hz, Note) —Use this parameter to specify whether

(“Note”) or not (“Hz”) the rate should be synchronized to the

Arranger or Recorder tempo. Depending on your choice, the

setting range of the following parameter refers to a speed (Hz)

or a note value.

z Rate [Hz] (0.05~10.00Hz) —Rate at which the 16-step sequence

will cycle.

z Rate [note] (musical notes) —Rate parameters can be set as a

note-value of a tempo if you set the “Sync” parameter above to

“Note”. Specify the value of the desired note.

z Attack (0~127) —Speed at which the pan changes between

steps.

z Input Sync Sw (O, On) —Species whether an input note

will cause the sequence to resume from the rst step of the

sequence (ON) or not (OFF).

z Input Sync Threshold (0~127) —Volume at which an input note

will be detected.

z Level (0~127) —Output level.

56. Slicer

By applying successive cuts to the sound, this eect turns a

conventional sound into a sound that appears to be played as a

backing phrase. This is especially eective when applied to sustain-

type sounds.

z Step 1~16 (0~127) —Level at each step.

z Rate [sync] (Hz, Note) —Use this parameter to specify whether

(“Note”) or not (“Hz”) the rate should be synchronized to the

Arranger or Recorder tempo. Depending on your choice, the

setting range of the following parameter refers to a speed (Hz)

or a note value.

z Rate [Hz] (0.05~10.00Hz) —Rate at which the 16-step sequence

will cycle.

z Rate [note] (musical notes) —Rate parameters can be set as a

note-value of a tempo if you set the “Sync” parameter above to

“Note”. Specify the value of the desired note.

z Attack (0~127) —Speed at which the level changes between

steps.

z Input Sync Sw (O, On) —Species whether an input note

will cause the sequence to resume from the rst step of the

sequence (ON) or not (OFF).

z Input Sync Threshold (0~127) —Volume at which an input note

will be detected.

z Mode (Legato, Slash) —Sets the manner in which the volume

changes as one step progresses to the next.

LEGATO: The change in volume from one step’s level to the next

remains unaltered. If the level of a following step is the same as

the one preceding it, there is no change in volume.

SLASH: The level is momentarily set to 0 before progressing to

the level of the next step. This change in volume occurs even if

the level of the following step is the same as the preceding step.

z Shue (0~127) —Timing of volume changes in levels for even

numbered steps (step 2, step 4, step 6…). The higher the value,

the later the beat progresses.

z Level (0~127) —Output level.

57. VK Rotary

This type provides modied response for the rotary speaker, with

the low end boosted further.

This eect features the same specications as the VK-7’s built-in

rotary speaker.

z Speed (Slow, Fast) —Rotational speed of the rotating speaker.

z Brake (O, On) —Switches the rotation of the rotary speaker.

When this is turned on, the rotation will gradually stop. When it

is turned o, the rotation will gradually resume.

z Woofer Slow Speed (0.05~10.0Hz) —Low-speed rotation speed

of the woofer.

z Woofer Fast Speed (0.05~10.0Hz) —High-speed rotation speed

of the woofer.

z Woofer Trans Up (0~127) —Adjusts the rate at which the

woofer rotation speeds up when the rotation is switched from

Slow to Fast.

z Woofer Trans Down (0~127) —Adjusts the rate at which the

woofer rotation slows down when the rotation is switched from

z Fast to Slow.

z Woofer Level (0~127) —Volume of the woofer.

z Tweeter Slow Speed (0.05~10.0Hz) —Low-speed rotation

speed of the tweeter.

z Tweeter Fast Speed (0.05~10.0Hz) —High-speed rotation

speed of the tweeter.

z Tweeter Trans Up (0~127) —Adjusts the rate at which the

tweeter rotation speeds up when the rotation is switched from

Slow to Fast.

z Tweeter Trans Down (0~127) —Adjusts the rate at which the

tweeter rotation slows down when the rotation is switched from

Fast to Slow.

z Tweeter Level (0~127) —Volume of the tweeter.

z Spread (0~10) —Sets the rotary speaker stereo image. The

higher the value set, the wider the sound is spread out.

z EQ Low Gain (–15dB~0~15dB) —Gain of the low frequency

range.

z EQ High Gain (–15dB~0~15dB) —Gain of the high frequency

range.

z Level (0~127) —Output level.

58. 3D Chorus

This applies a 3D eect to the chorus sound. The chorus sound will

be positioned 90 degrees left and 90 degrees right.

z Filter Type (OFF, LPF, HPF) —Type of lter. OFF: no lter is used.

LPF: cuts the frequency range above the Cuto value. HPF: cuts

the frequency range below the Cuto value.

z Cuto Frequency (200~8000Hz) —Basic frequency of the lter.

z Chorus Pre Delay (0.0~100.0ms) —Adjusts the delay between

the incoming direct signal and the moment when the chorus

starts working.

z Rate [sync] (Hz, Note) —Use this parameter to specify

whether (“Note”) or not (“Hz”) the modulation rate should be

synchronized to the Arranger or Recorder tempo. Depending on

your choice, the setting range of the following parameter refers

to a speed (Hz) or a note value.

z Chorus Rate (0.05~10.0Hz) —Frequency, i.e. modulation speed.

z Rate [note] (musical notes) —Rate parameters can be set as a

note-value of a tempo if you set the “Sync” parameter above to

“Note”. Specify the value of the desired note.

z Chorus Depth (0~127) —Modulation intensity.

z Phase (0~180 deg) —Spatial spread of the sound.

Roland BK-9 Tone Drum Kit List Seite 53

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info