Bedienungsanleitung Satel CA-10 (Seite 34 von 43) (Englisch)

699577

Zoom out

Zoom in

Vorherige Seite

1/43

Nächste Seite

32 Installer Manual SATEL

for a correct operation of most older-generation modems (i.e. modems with a maximum

speed of 2400 Bps). The fast modems of a new generation require some extra commands

being added to limit their operation speed.

Remote communication procedure:

• program in the control panel:

− FS2: control panel identifier by which the program recognizes the alarm system

− FS3: computer identifier by which the control panel recognizes the computer

authorized to establish connection

− FS4: computer telephone number (which is not necessary)

− FS5: “external DOWNLOADING” option, “double call” option (any setting) and the

FS101 – number of rings before answer – if communication is to be initiated from the

computer

• start the DLOAD10 program, select the CA-10 control panel and its version, e.g. by

opening the data of such a panel and select the “MODEM” item from the

„COMMUNICATION” menu.

Note: The communication identifiers and the „double call” option settings must be identical

in the control panel and in the alarm system computer data.

Telephone connection with the control panel will be set up automatically after selecting any

communication command in the program (Read, Write, Event log read, ON-LINE mode).

You can also start communication from the panel with the user function 0.

Telephone communication error messages:

• “modem not responding” – the modem has not acknowledged the dialed number

(a rare case, usually a problem caused by modem hardware or e.g. missing the “V1”

initializing command),

• “panel not responding”, “no panel's carrier”, “no panel's initial greeting”

“insufficient line quality or bad PC's communication password!”, “panel's

communication password does not match PC data”:

− connection with the control panel was unsuccessful,

− the control panel was off hook but did not answer the modem signal because it was

much corrupted,

− the control panel was off hook but did not answer the modem signal because it was

not in the transmission format V.21 or BELL 103 (incompatible or incorrectly

configured modem),

− the control panel established connection, but the identifiers in the control panel and

computer are different – the panel disconnects,

• “connection interrupt” – the control panel stopped answering the computer signals.

Note: If the control panel answers the call but fails to establish communication and

disconnects, while the “double call” option is deactivated, it will be answering no

calls for the next 5 minutes.

Programming the LCD keypad from the computer

Programming the LCD keypad data is only possible in the local mode. You can program the

following data:

− keypad options,

− names of zones, partitions and outputs,

− message contents,

− user names.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel CA-10 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel CA-10

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info