Bedienungsanleitung Satel CA-6 (Seite 12 von 36) (Englisch)

699578

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

10 SATEL Installer Manual

which waits for one specific signal for a predetermined period of time and only redials upon

detecting that that signal has not occurred.

Dialer

The CA-6 is equipped with a telephone dialer, which enables an alarm voice message to be

transmitted. The message is stored in an external synthesizer. The control panel directly

interfaces with the SATEL SM-2 voice synthesizer. The dialer can also establish connections

with paging systems. Two different alphanumeric messages can be programmed.

The CA-6 allows programming of four telephone numbers, 16 characters each. The numbers

can be individually assigned to partitions, or, alternatively, one number can be assigned to

both partitions. As the control panel is capable of establishing connections with paging

systems, each number can be assigned one of the two text messages, or a voice message

from the synthesizer.

During the procedure of connection setup, the panel controls signals from the telephone line

(algorithm ToneLOGIC). Hence, it can recognize that the call is answered, irrespective of the

type of telephone exchange. In order to enhance the efficiency of messaging, it is possible to

increase the number of calling rounds.

Messaging for each telephone number is realized in accordance with the following

parameters:

• round count (1 to 7) – defines how many times it is necessary to call and send

information to each number,

• max. redial number for one round (1 to 9) – number of attempts, after which the

panel will stop dialing the number, for which connection cannot be established

(no answer, permanently busy, etc.).

Messaging can be carried on until successful. It is also possible to determine the maximum

number of retries (from 1 to 9), after which the panel stops dialing the number for which

connection cannot be established (no answer, permanently busy, etc.). When waiting for the

dial tone during dialing (code D, when the control panel is connected to an extension line and

is trying to get the outside line), detecting the busy signal does not decrease the counter of

rounds and attempts.

The control panel dialer function can answer the calls and give information on the system

state with a voice message (if one hour has not elapsed yet after the alarm) or with special

signals (one beep a second if there was no alarm, or five short beeps every second if one

hour has elapsed from the alarm).

Another way of getting information on the system state via the telephone is through the

control panel operation in conjunction with the SATEL MST-1 module (service function

FS131). Additionally, this module enables the system to be remotely controlled, within certain

limits, by means of DTMF signals. For the connection diagram refer to the MST-1 module

operating instructions.

Remote Programming – DOWNLOADING

In order to facilitate programming, the CA-6 is equipped with a DOWNLOADING function,

which enables a PC computer to be used for programming and controlling of the alarm

system by means of the DLOAD10 program.

The DLOAD10 program, which is delivered with the control panel, enables:

• reading all control panel parameters,

• writing new parameters to the control panel,

• reading the system event log,

• ONLINE operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel CA-6 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel CA-6

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info