Bedienungsanleitung Satel CA-6 (Seite 11 von 36) (Englisch)

699578

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

CA-6 SATEL 9

It is possible to signal the exit delay or entry delay time, trouble, violation of a CHIME option

zone, violation of a DAY/NIGHT and COUNTING zone, alarm. You can also disable the

signaling of key depression and confirmation of the function performed.

The basic information on the system state is provided by means of light emitting diodes. They

present the state of zones and partitions (armed, alarm), as well as information on the status

of power supply and telephone line, as well as on troubles found.

The following features are also provided:

• setting the keypad backlight mode with the key 9: none, automatic, permanent.

In the CA-6 KLED keypad, the backlighting can be switched on/off by means of pins

located next to the terminal block on the keypad board.

• visualization of the keypad audible signal – buzzer (CA-6 KLED-S).

The keypad has an address, which makes difficult replacement or connection of another

keypad, an individual tamper contact and two zones, which operate identically as the zones

of the control panel mainboard. The keypad zones can be assigned to any partition. The data

concerning address, tamper contact and zone status, are sent to the control panel together

with keypad data.

Provision is made for connecting several keypads in parallel (which does not increase the

number of control panel zones).

Monitoring

The CA-6 control panel can transmit information about the system (partition) status to one or

two monitoring stations. Communication with the monitoring stations takes place irrespective

of the voice messaging and the messaging to paging systems. It has a priority and is realized

before the voice messaging. In case problems occur with getting connected to the station, the

control panel will suspend dialing the station number for 60 seconds and, if the message is

also to be transmitted by the dialer, it will make the line available to the dialer.

There are a few ways of transmitting information to the monitoring stations:

• Reporting to one station.

• Reporting to Station 1, and if unavailable – to Station 2 (e.g., when the station has

two telephone numbers). If this is the case, all events are reported, irrespective of

which station was reached by the control panel.

• Reporting to both stations with event sorting – depending on what event occurred

in the system, for example, information on alarms to Station 1, and information on

troubles to Station 2 (this mode is useful where the station serves many subscribers

and it is necessary that the number likely to receive most vital information be busy as

little as possible). In this mode, during control panel programming, you can determine

which information is to be sent to which station.

• Reporting to both stations: Station 1 first, then Station 2. This mode is reached by

assigning the same event to both stations.

It is possible to send information on events related to zones, partitions, as well as system

events. The event codes for both stations are the same. It is possible to define how the

events are to be divide between the two stations. Information can be transmitted to the

stations in one of fifteen formats (including Contact ID).

Because of analysis of commutation signals (algorithm ToneLOGIC), the CA-6 controls the

process of establishing connection with the station, which in case of the line being frequently

busy considerably reduces the time between occurrence of the event and sending

information to the monitoring station. As dialing retries are made immediately after detecting

the busy signal, the connection is established many times faster than with the equipment

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel CA-6 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel CA-6

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info