Bedienungsanleitung Satel CA-6 (Seite 22 von 36) (Englisch)

699578

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

20 SATEL Installer Manual

the battery "-". Connecting the common ground of the device to the battery "-"

will result in faulty operation of the charging current limiter, which will

eventually lead a quick discharge of the battery, or may even cause damage to

the control panel.

Connections of Telephone Line

If the control panel telephone communicator is used in the alarm system (for monitoring,

messaging or remote programming), it is necessary to connect telephone line to the control

panel. It should be led to a connector situated on the right side of the printed board. In order

to ensure proper messaging, the control panel must be directly connected to the line

(terminals designated as TIP and RING), and any other devices (telephone, telefax) – after

the control panel (terminals designated as T-1 and R-1). Such a connection will make it

possible for the control panel to fully engage the line for the time of calling, which prevents

the messaging function from being blocked by lifting the handset. Additionally, the telephones

connected after the control panel do not signal the dialing by the control panel.

The telephone line must be a four-wire line so that the control panel can be connected

before the other devices (telephone, telefax, etc.).

Notes:

• Do not send telephone signals and alarm system signals by one multicore cable. This may

result in damage to the system in case of a high-voltage punch-through from the telephone

line.

• Telephone terminals of the panel should be connected to PSTN (analog) lines only.

Connecting the telephone circuit directly to digital network (e.g. ISDN) will cause damage

to the equipment.

• The system installer should give the necessary information on the way of connection

control panel to telephone network to the user.

Connection of Voice Synthesizer

Where the function of alarm messaging with

voice announcements is used, a voice

synthesizer must be connected to the control

panel. The CA-6 interfaces with the SM-2

synthesizer produced by SATEL.

The synthesizer socket (designated as: SM-2

VOICE SYNTHESIZER) is located at the right

side of PCB, between telephone line

connector and low-current output sockets.

The SM-2 synthesizer should be directly

plugged into this connector. It is fitted with

minijacks for playback of the message and

monitoring of the telephone line.

Connection of power supply

The control panel is permanently connected to the mains supply source. Hence, before

making the connections it is necessary to familiarize with the electric system in the facility.

For powering the control panel choose the circuit which is always live. The power supply

circuit should be protected with a proper fuse.

common ground

low-frequency signal

triggering

teltphone line monitoring

+ power supply (12 V)

panel board

Fig. 13. Arrangement of signals on SM-2

voice synthesizer connectors.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel CA-6 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel CA-6

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info