Bedienungsanleitung Satel Versa Plus (Seite 74 von 110) (Englisch)

699394

Zoom out

Zoom in

Vorherige Seite

1/110

Nächste Seite

72 VERSA Plus SATEL

The mode of operation of wireless detectors depends on the status of partition to which the

zone with wireless detector belongs:

partition disarmed – the detector operates in passive mode. It is a battery saving mode, in

which communication with the controller takes place mainly during time intervals

determined by the RESPONSE PERIOD parameter. At that time, information on violations and

battery status is sent. Only detector tampers are sent immediately.

partition armed – the detector operates in active mode. The detector sends immediately all

information to the controller.

Because switching the detectors over from the passive into active mode and conversely

takes place during the response time, it is performed with some delay in relation to

arming/disarming. The maximum delay – depending on the selected response frequency –

can be 12, 24 or 36 seconds.

The AMD-103 detector and the wireless detectors assigned to 24-h zones, i.e. always armed,

are in active mode at all times. Also other wireless detectors can always operate in active

mode, if the A

LWAYS ACTIVE option is enabled for them (see: “Parameters and options of

ABAX system wireless devices” p. 65).

According to the EN50131-3 standard all ABAX system

Hold-Up devices must be

always in active mode.

Batteries ensure approx. 3 years operation of the detectors, assuming that the

detectors are in passive state for part of that period and the RESPONSE PERIOD is 12

seconds. A longer response period (24 or 36 seconds) means extension of the battery

life time. The battery life time in the detectors switched permanently into the active

mode is shorter than in those which are periodically switched to the passive mode.

However, if the specific character of a detector or its installation place is such that the

number of violations is low, switching the detector permanently into the active mode

will not adversely affect the battery life time.

ABAX wireless sirens

The wireless sirens take up 2 outputs and 2 zones in the system. How the signaling is

controlled by the outputs depends on the siren:

ASP-100 – the first output controls acoustic signaling, and the other one – optical signaling.

The command to start or stop the signaling is sent to the siren immediately. The signaling

stops after the maximum duration of signaling elapses, even if the control output is still

active.

ASP-105 – the first output controls acoustic signaling, and the other one – optical signaling.

The command to start or stop the signaling is sent to the siren immediately. The acoustic

signaling stops after the maximum duration of acoustic signaling elapses, even if the

control output is still active. The optical signaling is active as long as the output is active.

ASP-205 – both outputs control acoustic and optical signaling. Thus two different,

independently triggered ways of signaling can be configured. As a result, the outputs can

separately control the optical and acoustic signaling or signal different alarm types (e.g.

burglary and fire). The command to start the signaling is sent to the siren only during the

response time. Therefore, the cut-off time for the control panel outputs which control the

siren must be longer than the response period. It is recommended that cut-off time

correspond to maximum duration of signaling programmed for the siren. The signaling

stops after the maximum duration of signaling elapses, even if the control output is still

active.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel Versa Plus Seite 74

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel Versa Plus

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info