Bedienungsanleitung Scheppach Basa 5.0 (Seite 29 von 148) (Alle Sprachen)

781468

Zoom out

Zoom in

Vorherige Seite

1/148

Nächste Seite

evenly using both hands with the ngers together.

Hold the workpiece with your hands on a safe

area.

• Use a pattern for repeated arced or irregular cuts.

• Insure that the workpiece does not roll when

cutting round pieces.

• Use the traverse cutting gauge special acces-

sory for safety when making traverse cuts.

• To safely cut round plates, use the circular cut-

ting unit special accessory.

Electrical Connection 

 The installed electric motor is connected

and is ready to work.

The connection complies with the relevant VDE

and DIN regulations.

The customer-side mains supply and the used

extension line must meet these regulations.

Installations, repair, and maintenance work

relating to the electric installation may only be

performed by specialists.

Important Notes

The electric motor has been designed for the S 1

operating mode.

In case of an overload of the motor, it turns off

automatically. After a cooling period (duration

varies), you can turn on the motor again.

 Defective Electric

Connection Lines

Often, insulation damages occur on electrical

connection lines.

Causes are:

1. Drag marks if connection lines are led through

window or door clearances.

2. Kinks due to improper attachment or routing of

the connection line.

3. Cuts caused by running over the connection

line.

4. Insulation damages caused by pulling the con-

nection line out of the wall socket.

5. Fissures caused by the ageing of the insulation.

Such defective electric connection lines must

not be used and are hazardous due to the

insulation damages.

Regularly check the electrical connection lines for

damages. Please make sure that the connection

lines are disconnected from the mains supply

during the check.

Electrical connection lines must comply with the

relevant VDE and DIN regulations. Only use con-

nection lines labelled with H 07 RN. The labelling

of the connection cable with the type specication

is required.

AC motor

1. The supply voltage must be 230 V / 50 Hz.

2. Extension lines up to a length of 25 m must

have a cross section of 1.5 square millimetres.

Extension lines with a length of more than 25

m must have a minimum cross section of 2.5

square millimetres.

3. The mains connection is protected with a delay-

action fuse of 16 A.

Rotary current motor

1. The supply voltage must be 400 V / 50 Hz.

2. Mains supply and extension line must be ve-

wire = 3 P + N + SL.

3. Extension lines must have a minimum cross

section of 1.5 square millimetres.

4. The mains connection is protected with a maxi-

mum of 16 A.

5. In case of mains supply or change of location,

the direction of rotation must be checked. If

required, the polarity must be reversed.

If you have further questions, please specify

the following:

1. Motor manufacturer

2. Kind of current of the motor

3. Data from the machine type plate

4. Data from the switch type plate

If you return the motor, always return the com-

plete drive unit with the switch.

Maintenance

Carry out retting, setting measurement and

cleaning work only when the motor is switched

off. Pull the plug and wait for the sawband to

come to a full stop.

An experience worker can carry out minor-

repairs on the machine himself.

Repair and maintenance work on the electrical

system may only be carried out by a qualied

electrician.

All protective and safety devices must be re-

attached immediately after completed repair

and maintenance work.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Scheppach Basa 5.0 Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info