Bedienungsanleitung Scheppach HTH250 (Seite 23 von 104) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Polnisch, Schwedisch)

782035

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

23GB

6. Technical data

HTH250/240P

Technical data

Cutting data Hedge Trimmer

Engine Type 2 - stroke engine - air cooled

Capacity cm325,4

Engine power kW 0,7

Idle speed n0/min-1 3400

Max. Engine speed min-1 9500

Fuel tank capacity l 0,6

Mixing ratio (fuel / two-stroke oil) 40:1

Cutting length mm 600

Max. cutting thickness mm 27

Dimension L/B/H mm 1165/230/220

Sword length mm 690

Weight kg 5,9

Subject to technical changes!

Information concerning noise emission measured ac-

cording to relevant standards:

Sound pressure LpA = 96 dB(A)

Sound power LWA = 108 dB(A)

Uncertainty KpA = 3 dB(A)

Wear ear-muffs.

The impact of noise can cause damage to hearing.

Vibration (real handle) Ahv = 6,9 m/s2

Uncertainty Khv = 1,5 m/s2

7. Before starting the equipment

The hedge trimmer is supplied without fuel.

Fuel the hedge trimmer as described under “Fuelling”.

Fuelling

• This device is operated by a mixture from regular pet-

rol (unleaded) and two-stroke engine oil.

Utmost care is required when handling fuel and oil.

Keep away smoke and open ames (risk of explo-

sion).

Petrol

Petrol: Octane number at least 91 ROZ unleaded

• Do not ll in leaded petrol, diesel or other non-ap-

proved fuels.

• Do not use petrol having a smaller octance number

than 91 ROZ. This may lead to severe engine dam-

ages due to increased engine temperatures.

• If you frequently operate the device at high speeds,

you should use petrol with a higher octane number.

• The use of unleaded petrol is recommended for envi-

ronment protection reasons.

Two-stroke engine oil:

acc. to JASO FC or ISO EGD specications

Do not use

- four-stroke oil or two-stroke oil for water-cooled out-

board engines,

- mixtures ready for use from petrol stations.

Mixing

Ratio of mixture: 40:1

Petrol Two-stroke engine oil 2,5% (40:1)

1 litres 0.025 litres

2 litres 0.05 litres

5 litres 0.125 litres

10 litres 0.25 litres

• Measure the oil quantity accurately as a small devia-

tion of it has a large effect on the ratio of mixture in

particular for small fuel quantities.

• Do not change the ratio of mixture. This will lead to

more residues of combustion, a higher fuel consump-

tion, a decrease of output or damages to the engine.

Mix petrol and oil in a clean container approved for pet-

rol and appropriately identied. Use a fuel container

with overll protection.

1. At rst ll in half the quantity of petrol to be mixed.

2. Then ll in the total amount of oil.

3. Shake the fuel mixture.

4. Fill in the remaining quantity of petrol.

Fuels have only a limited shelf-life, they are subject to

ageing. Outdated fuels and fuel mixtures may result in

starting problems. Therefore, mix only that quantity of

fuel which you can use within a month. Only store fuels

in containers approved and identied for this. Keep fuel

containers in a dry and safe area.

Make sure that fuel containers are kept out of the

reach for children.

Caution! Prior to starting the machine learn how to put it

out of action in emergency cases.

Fuelling the hedge trimmer

• Stop the engine and allow it to cool down.

• Wear protective gloves.

• Avoid eye and skin contact.

• Strictly follow the instructions under “Safe handling

with fuels”.

1. Only fuel the hedge trimmer in the open or in suf-

ciently ventilated rooms.

2. Clean the area around the ller neck. Contamina-

tion in the tank may result in malfunction.

3. Shake the container once more before pouring the

fuel mixture into the tank.

4. Carefully open the tank cap (10) to allow possible

overpressure to relax.

5. Carefully ll the fuel mixture up to the lower edge

of the ller neck.

6. Close the tank cap. Check that the tank cap is

tight.

7. Clean the tank cap and the area around it.

8. Check the tank and the fuel lines for leaks.

9. Operate the fuel pump (11) if required.

10. Before starting the engine go away at least three

metres from the fuelling place.

8. Attachment and operation

You may not start to operate the machine until you have

read these operating instructions, observed all the in-

structions given and completely and properly assem-

bled the machine!

- Make sure that the ON/OFF switch (6), the throttle

lock-out switch (7) and the throttle trigger (14) func-

tion perfectly.

- This hedge trimmer is only allowed to be started after

it is completely assembled.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Scheppach HTH250 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info