Bedienungsanleitung Scheppach SG3400i (Seite 24 von 120) (Deutsch, Englisch, Französisch, Italienisch)

781618

Zoom out

Zoom in

Vorherige Seite

1/120

Nächste Seite

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

24 | GB

8. Operation

8.1 Starting the engine (Fig. 4 - 5)

Attention! This generator can only be started when

the battery is connected!

• Fuel tap switch (8) on position “ON” (Fig. 4)

• Set the start, stop switch (10) to the “RUN (I)“ po-

sition.

• You now have three options for starting the gen-

erator.

- Set the start, stop switch to the Start (II) posi-

tion.

- Use the enclosed remote control (D) to start the

generator, to do so, press the “ON” button.

- Use the recoil starter (6) to start the engine; to

do so, pull the handle forcefully. Move the recoil

started back to the original position carefully

and slowly. If the engine does not start, pull on

the handle again.

8.2 Switching off the engine

• Let the generator run briey without load before

you turn it off, so that the aggregate can “recooling”

• Press the “OFF” button on the remote control (D) or

set the start, stop switch to the “STOP” position (O).

• Move the Fuel tap switch to position “OFF”.

Indicator lights

Oil warning light (A)

Display is active at low oil level and deactivated when

sufcient oil level.

Overload indicator (B)

Overload protection is active at too high a power

take-off - Turns off 230 V sockets (16).

Turn off the unit (see section 8.2).

Connected devices from separate generator. The unit

(see section 8.1).

Operating display (C)

Power indicator active - when the engine is running.

8.3 Energy saving switch (9)

If the energy saving switch is switched to the “ON” (

) position, the engine runs automatically at idle

unless a consumer is connected. If a consumer is

connected, the engine returns to its full speed. This

setting is recommended to minimise the fuel con-

sumption.

Attention!

Set the energy saving switch (9) to the “OFF” position

() if a high power device is connected or if several

devices are connected. Then wait until the genera-

tor has absorbed the load, switch the energy saving

switch on as required.

Attention! This generator can only be started when

the battery is connected!

Attention! Fill the oil before rst use.

Before each use, check the oil level with the engine

switched off and on a level surface. Use the highest

quality four-stroke oil or an HD oil with the same level

of quality.

SAE 10W30 / 15W40 is recommended for general

use at all temperatures.

Connecting the battery

Release the battery compartment cover by undo-

ing the two screws using the enclosed Phillips head

screwdriver. Now connect the red cable to the plus

pole (+) and the black cable to the minus pole (-).

Note: The battery charges itself during operation.

Checking the oil level, g. 6 - 7

Remove the cover (6) (Fig. 6)

Unscrew the dipstick and clean it.

Check the oil level by inserting the dipstick into the

lling nozzle without screwing the cap on.

If the oil level is too low, rell with the recommended oil.

The oil level must be between min. and max. (Fig. 7)

Filling with fuel

• To refuel - cap (4) open counter clockwise.

• Fill fuel tank in

• Closing tank - tank cap (4) clockwise.

Recommended fuel

Unleaded regular gasoline with a research octane

number of 91 or higher is required for this engine.

Use only fresh and clean fuel.

m Water or impurities in the petrol damage the fuel

system.

Tank volume: 7,4 litre

m Refuel in a well-ventilated area with the

stopped engine. If the engine has been running,

allow it to cool rst. Never refuel the engine in-

side a building where gasoline fumes may reach

ames or sparks.

Petrol is highly ammable and explosiv. You can

get burns or other serious injuries when handling

fuel.

• Switch off the engine and keep it away from heat,

sparks and ames.

• Refuelling only outdoors.

• Immediately clean up spilled petrol.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Scheppach SG3400i Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info