664187
5
Zoom out
Zoom in
Vorherige Seite
1/15
Nächste Seite
8 scott-sports.com 9
BMXENGLISH
BIKE OWNER’S MANUAL
BRAKES
Brake adjustment general
Your SCOTT bike is fitted with a reliable and well-functioning braking system, provided
the brakes are correctly adjusted. Check by measuring the distance between the brake
shoes and the rim: it should be 1.5 to 2 mm.
Cable connection and adjustment of the (Dual Pivot) brake
1. Put the quick lever on the closed position.
2. Adjust the brake shoe clearance (as shown in the illustration) and secure the cable
with the pinch bolt nut.
Cable bolt tightening torque 6-8 Nm
Caliper brake
Release counter nut A and turn adjustment screw B counter clockwise until the
distance between brake pads and rims is approx. 2mm on each side.
Tighten counter nut A.
- In case adjustment screw B is released already to the limit, please release cable
clamping screw C and turn adjustment screw clockwise to its original position.
- Close the caliper brake with your hand to the rim , adjust the brake cable and tighten
clamping screw C. Please note the table of tightening torques at the end of this file.
- Finally make the fine tuning with adjustment screw B as mentioned above.
The wheel needs to spin free without touching the brake pads. Fix counter nut A.
Important:
Make sure that the brake works perfectly.
Important:
Under wet conditions the brake performance can decrease which will result in a
prolongation of the braking distance.
B
A
C
V-Brakes
1. While holding the shoe against the rim, tighten the shoe fixing nut.
2. Pass the inner cable through the inner cable lead, and after setting so that the total
of the clearances between the left and right shoes and the rim is 2 mm tighten the
cable fixing bolt.
Anzugsdrehmoment:
6 – 8 Nm
BC
B
+
C
=
2 mm
inner cable lead
5mm allen key
tightening torque :
6-8 Nm (52-69 in. lbs.)
3. Adjust the distance with the spring tension adjustment screws.
4. Depress lever about 10 times
Bremshebel circa 10
mal anziehen
Federeinstellschraube Federeinstellschraube
1 mm 1 mm
12
1 1
2 2
Spring tension
adjustment screw
Spring tension
adjustment screw
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Scott BMX - 2014 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Scott BMX - 2014

Scott BMX - 2014 Bedienungsanleitung - Deutsch - 15 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info