Bedienungsanleitung Seagate BlackArmor Back-up (Seite 123 von 130) (Englisch)

468758

123

Zoom out

Zoom in

Vorherige Seite

1/130

Nächste Seite

Heads (Hd)

Sectors (Sec)

Mode

Auto

CHS

1707 MB

Maximum LBA Capacity

1707 MB

In BIOS setup, you can set the Type parameter to User Type HDD (user-defined

type). In this case, you also have to specify the value of the translation mode

parameter, which can be Auto/Normal/LBA/Large.

Translation mode is how sector addresses are translated. This parameter appeared because

in BIOS versions, there were limitations to the maximum address capacity of disks, which is

504 MB (1024 cylinders x 16 heads x 63 sectors x 512 bytes). There are two ways to

bypass this limitation: (1) switch from physical to logical sector addresses (LBA), (2) use

mathematics to reduce the number of addressed sectors (cylinders) and increase the

number of heads; this method is called Large Disk (Large). The simplest decision is to set

the value of this parameter to Auto.

If there are several hard disks connected to your motherboard, but you do not want

to use some of them at the moment, you have to set the Type of these disks to Not

Installed.

Parameters of hard disks can be set manually with the help of information provided

by the hard disk manufacturer on its case, but it is easier to use the IDE

autodetection utility that is usually included in modern BIOS versions.

The utility is sometimes a separate BIOS menu item and is sometimes included in

the standard CMOS setup menu.

Please note that in "Appendix B. Hard disks and BIOS setup", we have described the

general details of the physical hard disk structure. Built-in IDE hard disk controls mask the

physical disk structure. As a result, the BIOS of the motherboard "sees" logical cylinders,

heads and sectors. We are not going to elaborate on this issue here, but knowing about this

can sometimes be useful.

B.2.3 Arranging boot sequence, advanced CMOS setup menu

Aside from standard CMOS setup, the BIOS menu usually has an advanced CMOS

setup item. Here you can adjust the boot sequence: C:; A:; CD-ROM:.

Please note that boot sequence management differs for various BIOS versions, e.g. for

AMI BIOS, AWARDBIOS, and brand-name hardware manufacturers.

Several years ago, the operating system boot sequence was hard-coded into the

BIOS. An operating system could be booted either from a diskette (drive A:), or

from the hard disk C:. That was the sequence in which the BIOS queried external

drives: if drive A: was ready, BIOS attempted to boot an operating system from a

diskette. If the drive was not ready or there was no system area on the diskette,

BIOS tried to boot an operating system from hard disk C:.

At present, BIOS allows booting operating systems not only from diskettes or hard

disks, but also from CD-ROMs, DVDs, and other devices. If there are several hard

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Seagate BlackArmor Back-up Seite 123

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info