Bedienungsanleitung Sharp XV-Z17000 (Seite 76 von 81) (Englisch)

469881

Zoom out

Zoom in

Vorherige Seite

1/81

Nächste Seite

Troubleshooting

(Continued)

-74

Problem Check Page

3D images are not

displayed.

• Switch to 3D mode.

53, 54, 55

• Is “3D Auto Change” set to “No”? Press 3D ON/OFF to switch to 3D

mode.

• If “3D Auto Change” is set to “Yes” but no 3D images are displayed,

check the display format of the content being viewed. Some 3D image

signals may not be recognized as 3D images automatically. Press 3D

MENU to select the appropriate display format for the 3D image.

55, 56

• The 3D Glasses are not turned on. 52

• The 3D Glasses are set to 2D mode. 52

• The 3D Glasses operate by receiving the infrared signal reﬂ ected onto

the screen. Do not place anything between the screen and the infrared

receiver on the 3D Glasses.

–

3D Images ﬂicker when

watching in a room.

• Images may appear to ﬂicker when ﬂuorescent light or ambient light

enters your vision.

-Turn off the lights.

-Block any ambient light.

–

Ghosting (a double image)

occurs without the image

appearing in 3D.

• Use “Invert” to change the setting. 55

• A signal that does not support 3D is being received. Check whether a

signal that supports 3D is being received.

• If the projector is connected to a computer for 3D image playback,

check that a stereoscopically-enabled application is being used.

- Use the applicable software

- Conﬁgure your 3D application at the correct 3D format, resolution and

refresh rate. To support 3D, your 3D application must be conﬁgured to

run at the correct settings for this projector.

–

• If there is strong ambient light, block the light. High intensity lighting can

interfere with communication between the 3D Glasses and the screen,

resulting in some ﬂicker.

–

• A picture simultaneously projected from more than two projectors may

not appear 3D. Use only one projector at a time.

–

The projected image is dark. • When a 3D image is projected, the screen may appear darker than nor-

mal.

–

The 3D Glasses turn off

automatically.

• Is there an obstacle between the 3D Glasses and the screen, or is some-

thing covering the infrared receiver on the 3D Glasses? The 3D Glasses

turn off automatically after 3 minutes if no signal is received. Do not

place anything between the screen and the infrared receiver on the 3D

Glasses.

–

Pressing the power button

on the 3D Glasses does not

cause the LED light to light.

• The battery in the 3D Glasses is exhausted. If the LED light does not light

after pressing the power button for more than one second, the battery is

exhausted. Replace the battery.

This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect

operation or interference. If this should happen, unplug the unit and plug it in again after more than

5 minutes.

XV-Z17000_E_US.indb 74XV-Z17000_E_US.indb 74 2010/12/17 11:16:512010/12/17 11:16:51

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sharp XV-Z17000 Seite 76

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sharp XV-Z17000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info