Bedienungsanleitung Siemens HB34D553 (Seite 18 von 32) (Englisch)

527327

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

3.Fill the water tank with water only.

4.Start the È Descale operating mode as described.

You can also descale the evaporator dish manually.

Removing and fitting the appliance door

You can remove the appliance door to clean it more

thoroughly.

: Risk of injury!

The hinges of the appliance door may snap shut with great

force. Always open the hinge locking lever fully when removing

the appliance door and close it fully after refitting. Do not reach

into the hinge.

: Risk of injury!

If the appliance door has only been unhinged on one side, do

not reach into the hinge. The hinge can snap back with great

force. Call the aftersales service.

Removing the appliance door

1.Open the appliance door fully.

2.Fold out the locking levers on the left and right fully (figure A).

The hinges are secured and cannot snap closed.

3.Close the appliance door until you feel some resistance.

4.With both hands, grip the door on the left and right-hand side,

close the door a little more and pull it out (Fig. B).

Fitting the appliance door

Refit the appliance door after cleaning.

1.Insert the hinges in the left and right-hand bracket (figure C).

The notch on both hinges must engage.

2.Open the appliance door fully.

3.Close the locking levers on the left and right-hand side fully

(figure D).

The appliance door is secured and can no longer be

removed.

4.Close the appliance door.

Cleaning the door panels

To facilitate cleaning, you can remove the door panels from the

appliance door.

: Risk of injury!

The components inside the appliance door may have sharp

edges. Take care not to cut yourself. Wear protective gloves.

: Risk of injury!

The appliance must not be used again until the door panels

and appliance door have been correctly fitted.

Removing the door panel

Note: Before removing, make a note of the orientation in which

the door panel is fitted, so that it is not refitted the wrong way

round.

1.Unhook the appliance door and lay it on a soft, clean surface

with the front side facing downwards (see section: Removing

and installing the appliance door).

2.Unscrew the cover at the top left and right of the appliance

door and detach it (figure A).

3.Lift the door panel and remove it (figure B).

Removing the intermediate panel

Before removing, make a note of the position in which the

intermediate panel is fitted, so that you do not refit it the wrong

way round later.

1.Press the left and right-hand holders outwards.

2.Lift the intermediate panel slightly and take it out.

Cleaning

Clean the door panels with glass cleaner and a soft cloth.

Caution!

Do not use any sharp or abrasive medium or a glass scraper.

The glass could be damaged.

Fitting the intermediate panel

1.Insert the intermediate panel on the left and right into the

supports.

2.Push the intermediate panel downwards in the retainers.

Fitting the door panel

1.Slide in the door panel all the way.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens HB34D553 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Siemens HB34D553

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info