Bedienungsanleitung Siemens HB34D553 (Seite 19 von 32) (Englisch)

527327

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

2. Put the cover back in place and screw it in.

3. Refit the appliance door.

Cleaning the rails

The rails can be removed for cleaning.

: Risk of burning due to hot components in the cooking

compartment!

Wait until the cooking compartment has cooled down.

Detaching the rails

Note: Swing the front of the rail as far as possible (until you feel

resistance), because otherwise the appliance side panel may

become bent.

1. Carefully press the front of the rail upwards until it becomes

detached, and release it from the holder at the side (fig. A).

2. Detach the rail from the holder and remove it (fig. B).

3. Clean the rails with washing-up liquid and a sponge/brush

Clean the rails in the dishwasher.

Attaching the rail

1. Position the rail so that the indentations are facing upwards.

2. Hook the rail in at the back and push it towards the rear until

it engages (fig. C).

3. Hook the front of the rail onto the holder and press down until

it engages and is fixed level in place in the appliance once

more (fig. D).

Each set of rails only fits on one side.

Troubleshooting

Malfunctions often have simple explanations. Please read the

following instructions before calling the after-sales service.

Repairs may only be carried out by fully trained after-sales

service technicians. Incorrect repairs to your appliance may

present considerable risks for the user.

: Risk of electric shock!

■ Work on the appliance electronics may only be performed by

a specialist.

■ Always disconnect the appliance from the power supply

when work is carried out on the electronics. Switch off the

circuit breaker or remove the fuse from your household fuse

box.

Problem Possible cause Notes/remedy

The appliance does not work The plug is not plugged into the mains. Connect the appliance to the electricity

supply

Power cut Check whether other kitchen appliances

are working

Fuse defective Check in the fuse box to make sure that

the fuse for the appliance is OK

Faulty operation Switch the appliance off using the fuse in

the fuse box. Wait approximately

10 seconds and then switch it back on

Appliance does not start.

Nx ‹:…‹ min

appears in the display.

Cleaning aid or descaling was cancelled

Turn the operating mode selector to È or

calc and rinse the appliance twice

(see section "Cancelling the cleaning aid"

or "Cancelling descaling")

The appliance cannot be started The appliance door is not fully closed Close the appliance door.

The appliance is not in operation. A dura-

tion is shown in the display

A control knob was unintentionally

pressed

Press and hold the

† button

The

† button was not pressed after mak-

ing the setting

Press the † button briefly to start the

cooking operation, or press and hold the

† button to cancel the setting

Appliance does not start. A signal sounds A temperature outside of the possible tem-

perature range has been set

Check the temperature ranges for the

operating modes

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens HB34D553 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Siemens HB34D553

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info