Bedienungsanleitung Smeg FL 102 A (Seite 7 von 7) (Englisch)

73929

Zoom out

Zoom in

Vorherige Seite

1/7

Nächste Seite

Instructions for Use30

Ice Formation on the Inner Rear Wall

As long as the defrost water runs to the

channel and through the outlet to the drain pan

on the compressor, automatic defrosting of the

appliance is assured.

In case the ice formation on the inner back wall

is increased (3-5 mm), ice should be manually

defrosted.

Set the thermostat knob to STOP (0) position

and leave the door open. Never use electric

devices for defrosting and do not scrape the

ice or frost layer with sharp objects.

After completed defrosting, turn the knob to

desired position and close the refrigerator door.

The cause of increased ice formation may be

one of the following:

− the door does not seal well (clean the

gasket if it is contaminated, or replace it

if it is damaged);

− the door was frequently opened or it

was left opened for too long;

− the food stored in the refrigerator was

warm;

− the food or dish is touching the inner

back wall.

Water is Leaking From the Refrigerator

In case the discharge water outlet is clogged,

or the defrost water drips over the channel,

water leaks from the refrigerator.

• Clean the clogged outlet, for example with a

plastic straw.

• Manually defrost the increased ice layer.

See Ice Formation onthe Inner Rear Wall.

Noise

Cooling in refrigerating-freezing appliances is

enabled by the cooling system with

compressor, which produces noise. How noisy

the appliance is depends on where it is placed,

how it is used and how old the appliance is.

• During the operation of the compressor the

noise of liquid is heard and when the

compressor is not operating, the refrigerant

flow is heard. This is a normal condition and

it has no influence whatsoever on the

lifetime of the appliance.

• After starting the appliance, the operation

of the compressor and the refrigerant flow

may be louder, which does not mean that

something is wrong with the appliance and it

has no influence on the lifetime of the

appliance. Gradually the noise is reduced.

• Sometimes unusual and stronger noise is

heard, which is rather unusual for the

appliance. This noise is often a

consequence of inadequate placing.

− The appliance shall be placed and

levelled firmly on solid base.

− It should not touch the wall or kitchen

units standing next to it.

− Check the accesories in the interior of

the appliance, they should be placed

correctly in their positions; also check

the bottles, tins and other vessels that

might touch each other and rattle.

Bulb Replacement

Before replacing the light bulb, disconnect the

appliance form the power supply.

Press the cover at the rear side (in the arrow 1

direction) and remove the plastic cover (in the

arrow 2 direction). Replace the bulb with a new

one (E14, max. 15 W).

Don't forget: the old bulb does not belong to

organic waste.

Light bulb is consuming good therefore our

in-guarantee service does not relate to it.

WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO INFLUENCE

ON THE OPERATION OF THE APPLIANCE.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Smeg FL 102 A Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info