Bedienungsanleitung Spektrum DX8 (Seite 27 von 42) (Englisch)

708059

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite



Rotate the roller to highlight Flap System then press.



The Flap System defaults to Inhibit. To activate the Flap System, rotate the roller

to highlight Inhibit then press to access the switch function. Rotate the roller to

the desired Flaps control switch. Press to access that screen.



Rotate the roller to select desired Flap positions value then press the roller to

access that value. Now rotate to adjust the ﬂap position value. Note: it is

recommended that the ﬂap switch position match the ﬂap adjustment that

is being adjusted. This will allow you to observe the effects of the ﬂap adjustment.

Repeat this for all desired Flap and elevator positions (Normal, mid and land).



Rotate the roller to select Speed then press. Now rotate the roller to adjust the

ﬂap speed. Press the roller to accept. The ﬂap speed affects the ﬂap and elevator

compensation. The ﬂap and elevator will reach their ﬂap positions at the same time.



The Swashplate screen adjusts the amount and direction of travel for the aileron,

elevator and pitch functions when you activate CCPM mixing in Swash Type (see

pages 15-16). This screen also allows an Expo function that compensates for the

effect of the servo’s rotation at extremes of travel. An E-ring function also prevents

servo over-travel when simultaneous extreme aileron and elevator inputs are given.

Unless using a linear servo or a type of linkage that eliminates this effect, you

should turn on the Expo function when any CCPM mix is enabled. Swashplate

values increase or decrease the overall control travel of the selected channel. For

example if you increase Pitch value, the travel of all three servos that control pitch

will increase. If you increase aileron, the aileron and pitch servos will increase.

Increasing or decreasing this value affects the travel of that function and not the

individual servo. Note: Negative and positive swashplate values are available.

To achieve the correct travel direction for Aileron, Elevator and Pitch, ﬁrst use

the reversing function to set the servo direction on the aileron, elevator and pitch

channels. Do this so that when an aileron input on the transmitter’s stick tilts the

swashplate right and left, an elevator input tilts the swashplate fore and aft, and a

pitch input raises and lowers the swashplate. You synchronize the outputs with this

function. Then you can adjust swashplate values positively or negatively to achieve

the overall correct travel direction for aileron, elevator and pitch.



With the transmitter on and the main or telemetry screen displayed, press the

roller. The Function list displays.

Rotate the roller to highlight Swashplate then press to access.



Highlight the desired function (Aileron, Elevator or Pitch) then press the roller to

access.

Rotate the roller to change the Swashplate value, noting that positive and negative

values are available. Press the roller to accept.

Repeat the above process for all three cyclic inputs (aileron, elevator and pitch).



Rotate the roller to highlight EXPO then press to access. Spress the roller to

toggle between ACT and INH.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Spektrum DX8 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Spektrum DX8

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info