Bedienungsanleitung Spektrum DX8 (Seite 25 von 42) (Englisch)

708059

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite





The Throttle Cut function allows you to shut off an engine with the Trainer switch,

Gear switch or the Right or Left trimmer. When you activate the programmed

switch, the throttle channel is driven to it’s preprogrammed value normally off.

This effectively kills the engine. Release the programmed throttle cut switch/

trimmer, and normal throttle operation resumes.



With the transmitter on and the main or telemetry screen displayed, press the

roller. The Function list displays.

Rotate the roller to highlight Throttle Cut then press to access the Throttle Cut

screen.

Highlight Inhibit then press the roller to access the switch options.

Rotate the roller to the desired switch to cut the throttle (Trainer, Gear, Mix , L trim

or R trim) then press the roller to program that switch.

Program a Throttle Cut position. Note that 0%= low throttle, mid trim and

negative values are available. To test the Throttle Cut function, activate the

programmed switch. Note the throttle servo position or the position of the throttle

channel in the servo monitor. The system should drive the servo position to the

low throttle position when you activate Throttle Cut.



The Throttle Curve function allows throttle output vs. input positions to be

adjusted. This is typically used to alter the throttle response to give a linear rate

or to adjust the throttle response sensitivity when hovering or torque rolling. You

can program a single curve (switch to On) or up to three curves and select them

via a programmed switch. The screen displays a graphic 5-point throttle curve on

its left side to aid in selecting throttle curve values. An Expo function is available

that smoothes out the Throttle curve.



With the transmitter on and the main or telemetry screen displayed, press the

roller. The Function list displays.

Rotate the roller to highlight Throttle Curve then press the roller to access the

Throttle Curve screen.



Rotate the roller to highlight Switch then press the roller to access the switch

options.

Choose the desired switch to change to different throttle curves or select On if you

only want one curve to always be active.



With the switch listed at the bottom of the screen in the position desired for this

curve, rotate the roller to highlight one of the ﬁve available throttle curve values

(Low, 25%, 50%,75, High). Press the roller to access.

Rotate the roller to adjust the selected point to desired output. Note the position

on the graph at the left of the screen.

Repeat this for all desired points.

Note: if you select a switch position in Throttle Curve, move the switch

to the remaining position(s) and adjust the throttle curve values for those

switch positions.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Spektrum DX8 Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Spektrum DX8

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info