Bedienungsanleitung Spektrum DX8 (Seite 8 von 100) (Englisch)

708059

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite



STEP #7



The Throttle Cut function (normally used on gas or glow powered aircraft) allows

you to use the trainer button, mix switch or the Right or Left trimmer to shut off

an engine. Activating the programmed switch drives the throttle channel to its

programmed position regardless of the throttle stick position, powering down the

engine.



In the Function List rotate the roller to highlight Throttle Cut. Press the roller to

access the Throttle Cut screen.

Press the roller to highlight Inhibit. Rotate the roller to select the desired switch

to cut the throttle (Trainer, Gear, L trim, R trim or Mix). Press the roller to program

the selected switch.

Rotate the roller to highlight the Value and press the roller to access. A 0% value

gives low throttle, low trim. Adjust the value to the desired throttle cut position.

To test the throttle cut function, activate the programmed switch and note the

throttle servo position or the position of the throttle channel in the servo monitor.

STEP #8



Typically, you can use the Throttle Curve function to change the throttle response.

You can program a throttle that responds more proportionally to your input or

adjust the throttle response sensitivity when hovering or torque rolling. You can

program a single curve that is always on (ON). Or you can program up to three

curves and select them via a programmed switch. The Expo function can then

smooth out the Throttle curve.



In the Function List rotate the roller to highlight Throttle Curve. Press the roller to

access the Throttle Curve screen.



Rotate the roller to highlight “Inhibit”. Press the roller to access the switch options.

Choose the desired switch to change to different throttle curves. Alternatively, you can

select ON if only one curve is desired as always active.



With the switch listed at the bottom of the screen in the position desired for this

curve, rotate the roller to highlight one of the ﬁve available throttle curve values

(Low, 25%, 50%,75, High). Press the roller to access.

Rotate the roller to adjust the selected point to the desired output. Note the

position on the graph.

Repeat this for all desired points.

 if you set a switch position in Throttle Curve, move the switch so you can

adjust it. Change the throttle curve values for those switch positions.



Rotate the roller to highlight EXPO. Select Inh or Act to inhibit or activate the Expo

function.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Spektrum DX8 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Spektrum DX8

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info