Bedienungsanleitung Speroni CAM APM 200 (Seite 4 von 20) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

680602

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

• The noise (continuous equivalent in dbA) of

the motor-driven pumps is less or equal (≤) to

70 dbA.

• The voltage (230 Volts alternating current)

indicated on the pump rating plate must correspond

to the available mains voltage.

• The temperature of the liquid conveyed must not

exceed 35°C.

• Never attempt to lift or move the pump by stretching

the power-supply cable whilst it is plugged into the

mains.

• Make sure that the plugged electrical connections are

in an area safe from ooding and are protected from

humidity.

1. Safety Measures

•

• The user is liable towards third parties in the area where

the appliance is in operation.

• Before starting it is necessary to check that the

necessary electrical protection measures are met, by

means of a test carried out by a specialist.

WHILST using the pump, there should be

no person in the water or liquid to be

pumped, and the carrying out of any type

of maintenance is strictly forbidden.

The pump may be connected only by means of a

safety switch for fault currents, with an opening

rated current up to 30 mA and a socket with an

earth contact in compliance with the regulations.

Protection: at least 10 Amps.

The threephase pump must be equipped with

a thermal cutoff device appropriate to the

electrical characteristics shown on the

identiﬁcation plate.

Operation in swimming pools and garden ponds is

not recommended.

For other operation, the provisions in conformity with

the standard VDE 0100 part 702 must be respected.

CAUTION: Before checking, unplug the pump

from the mains!

Replacing the power supply cable requires using

special tools an

d therefore you must address to the

authorized after-sales service.

The pump may only operate with an extension

obtained through cable mod. H07 RNF and a thread

section of no less than 1 mm in compliance with the

DIN 57282 or DIN 57245 standard.

ELECTRIC SELF-PRIMING JET PUMP

• Before use it is necessary to check that the plug and

the mains connection line are not damaged.

• Unplug from the mains before performing any work on

the pump.

• Avoid directly exposing the pump to the jet of water.

• The user is responsible for complying with the local

regulations concerning assembly and safety.

• The user by taking appropriate measures (e.g. installing

an alarm, reserve pump and the like) will have to

exclude the possibility of indirect damage caused by

ooding premises due to failure of the pump.

• In the event of the pump failing, repair work may only

be carried out by the repair workshops of the technical

service. Only genuine spare parts must be used.

• It is notied that in conformity with the law on product

liability

we cannot be held responsible

for the damage caused by our appliance:

because of improper repairs not carried out by the

personnel of the assistance points authorized by us; or

b) if GENUINE SPARE PARTS are not used to replace

parts; or

c) if the indications and provisions given in the instructions

handbook are not complied with.

The same provisions hold for the accessories.

Resistance

This pump should not be used to convey inammable,

combustible or explosive liquids.

2. Use

CAUTION! Sector of use

• For irrigation and watering of lawns, gardens,

vegetable patches, etc.

• For operating garden sprinkler systems

• For drawing water from ponds, streams, water butts

and wells, subject to ﬁtting of suitable ﬁlter.

Acceptable liquids

In order to pump clear water (fresh water), rainwater

or non-aggressive chemical cleaning solutions.

Abrasive liquids or any other type of corrosive

liquid could damage or destroy the pump.

Operating Instructions

Generally speaking it is recommended to use a

preliminary ﬁlter and exhauster with a suction

hose, suitable and foot valve (reﬂux lock) to avoid

long suction times and pointlessly damaging the

pump due to stones and solid foreign bodies.

This appliance can be use d by children aged from 8 years and

above and persons with reduce physical,sensory or mental

capabilities or lack of experience and knowledge if they have been

given supervision or instruction concerning use the appliance in a safe

way and understand the hazards involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children

without supervision

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Speroni CAM APM 200 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info