593151
9
Zoom out
Zoom in
Vorherige Seite
1/48
Nächste Seite
Dimensions: (H x W x D) 113 x 78 x 73 mm
Output: 600 watts max . (resistive load, e.g. fi lament bulb)
500 watts max. (uncorrected, inductive,
cos φ = 0.5, e.g. fl uorescent tubes)
500 watts max. (series corrected)
500 watts max. (shunt corrected, at C ≤ 45.6 µF)
Electronic ballasts, capacitive
e.g. low-energy lamps,
6 each max., C ≤ 132 µF
Connection: 230 – 240 V, 50 Hz
terminal block suitable for following supply leads:
3-core Ø 1.5 or 2.5 mm
2
or 5-core Ø 1.5 mm
2
Angle of coverage: 160° with sneak-by guard
Pivoting range: 40° horizontal, 70° vertical
Reach: 12 m max.
Light threshold: 2 – 2000 lux
Time setting: 8 sec. – 35 min. (factory setting: 10 sec.)
Light threshold: 2 – 2000 lux (factory setting: 2000 lux)
Enclosure: IP 54
Temperature range: -20 °C to +50 °C
Technical specifi cations
Without power
W
Fuse blown, not
switched ‘ON’
W
Short circuit
W
Renew fuse, switch
‘ON’ mains power
switch, check wiring
with voltage tester
W
Check connections
Does not switch ‘ON’
W
Twilight setting in
nighttime mode during
daytime operation
W
Bulb blown
W
Mains switch ‘OFF’
W
Fuse blown
W
Detection zone not
properly targeted
W
Readjust
W
Replace bulb
W
Switch ‘ON’
W
Renew fuse, check
connection if
necessary
W
Re-adjust
Troubleshooting
Malfunction
Cause
Remedy
16
17
Remedy
Does not switch ‘OFF’
W
Continued movement
in detection zone
W
Light is in detection
zone and keeps switch-
ing on as a result of
temperature change
W
Set to continuous ope-
ration by indoor series
switch
W
Check detection zone
and re-adjust if neces-
sary or fi t shrouds
W
Readjust zone
W
Set series switch to
automatic mode
Keeps switchingON’/’OFF’
W
Light is in detection
zone
W
Animals moving in
detection zone
W
Change zone, increase
distance,
reduce output
W
Tilt sensor higher or
apply specifi c shrouds,
adjust detection zone
or fi t shrouds
Switches ‘ON’ when it
should not
W
Wind is moving trees
and bushes in the de-
tection zone
W
Cars in the street are
being detected
W
Sudden temperature
changes due to wea-
ther (wind, rain, snow)
or air expelled from
fans or open windows
W
Adjust detection zone
or fi t shrouds
W
Change detection
zone, tilt sensor down
W
Adjust detection zone
or change site of in-
stallation
Reach modifi cation
W
Change in ambient
temperatures
W
When it is cold,
shorten reach by tilting
sensor down
W
When it is hot, tilt
sensor up
CauseMalfunction
GB
9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Steinel IS 2160 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info