Bedienungsanleitung Strong SRT 7806 (Seite 26 von 30) (Englisch)

751654

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

After configuring, press RED to start the scanning with the selected settings.

Your receiver will now perform an automatic channel search. The scanning progress is displayed. During

the channel search you can skip transponders by pressing the MENU button or quit the scanning

process by pressing (required confirmation).

By the time the process is completed, all listed channels will be stored and the receiver will switch to the

first channel.

7.5.3 Information

This submenu shows all receiver related information e.g. hardware and software version. It also displays

technical information from the currently selected channel, signal strength and signal quality.

Please refer to the information given on screen when you call a hotline support. The support center

employee might ask for the information given on screen.

7.5.4 Factory Default

This submenu allows you to reset your receiver to the default factory settings. You will be asked to enter

the PIN code (default PIN code is 0000). Select Factory Reset to delete all settings and channels. Press OK

to confirm. Select Channel Reset to delete all channels. Press OK to confirm. All previous settings will not

be changed.

The receiver will reboot and start with the First Installation menu.

WARNING: A factory reset will permanently delete all your personal settings, timers and stored

channels. Please consider this before you perform a factory reset. Please use this

option with caution.

7.5.5 CA INFO

Smartcard Information

This menu section is only accessible when an HD+ smartcard is inserted into the receiver. It provides

information about the HD+ smartcard. Please consult your installer or card provider for information

regarding the usage of your HD+ smartcard.

NOTE: Always make sure to insert the smartcard with the golden chip facing down.

Mail List

This submenu allows you to read messages from the operator.

NOTE: Messages from the operator will be displayed at the upper left corner of the TV

screen, showing the icon. Press on the remote control or open the submenu

to read the message.

Use the p q buttons to select the message and press OK to open and read it. Press RED to delete all

messages from the list. Press GREEN to move up one page in the list. Press YELLOW to move down one

page in the list. Press BLUE to delete the selected message. Press button to return to previous step.

Press to exit the menu and go back to viewing mode.

8.0 TROUBLESHOOTING

There may be various reasons for faulty operation of the receiver. Please check the receiver according

to the procedures shown below. If the receiver does not work properly after checking it, please contact

your local service line or STRONG dealer. Alternatively you can send a support e-mail via our website:

www.strong.tv.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Strong SRT 7806 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Strong SRT 7806

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info