Bedienungsanleitung Telair Energy 2510b (Seite 19 von 40) (Englisch)

688849

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Vers. 002

Energy 2510 B

Should the battery be flat, you can start the gen-

erating set Energy 2510 B by hand, using the

handle of the engine coil winding (Fig.31 Ref.1)

after setting the selector switch to "ON" (Fig.31

Ref. 2) and the electronic control panel to "ON".

Once you have started up the engine manually,

put the selector switch back to "0FF" (Fig.31 Ref.

2). The start-up battery should never be discon-

nected, as there would be no input to the elec-

tronic control panel which would prevent the

generating set from working.

6.2 Turning the generating sets off

To stop the generating set, set the switch 1 to its

"OFF" position (Fig.30 Ref.1).

The fuel employed is

highly flammable.

The exhaust gases are conveyed under the

casing; their temperature, inevitably, is high

even though they are mixed with cooling air.

Do not touch the casing areas near the ex-

haust, and do not put your hands or any ob-

jects inside the casing.

6.3 Information on not recommended uses

These generating sets

must be installed and used by qualified and

authorised personnel only, according to the

manufacturer’s instructions. These generat-

ing sets must only and exclusively be used to

produce electrical power on vehicles pro-

vided with an electrical system built to stan-

dards and according to the quantity of power

delivered.

6.4 Useful tips

To prevent malfunctioning of any of the

generating set-powered users, it is necessary to:

- Before starting the generating set, ensure all

user loads are disconnected (e.g. via the

thermomagnetic switch provided between the

generating set and the system - as described

elsewhere in this document) until the

generating set has started and reached

steady state.

- Before stopping the generating set,

disconnect or at least, turn off the connected

users.

To make the best use of the generating sets, re-

member that even minor overloads - if they last

long enough - will operate the thermal cut-out

switches (Fig.31 Ref.3).

During the first 50 hours of operation (run-in

time), it is important not to submit the generating

set to a working load exceeding 75% of its rated

load.

6.5 Control and alarm functions (Fig. 30)

2 Display: when the generating set has started

up, the total running hours will be displayed.

Press the key provided below the control panel

display unit (Fig.30 Ref.9) to display the number

of generating set operation hours since the latest

engine oil change.

3 High temperature indicator: this warning light

will light up when the temperature of the generat-

ing set goes over its safety value; the engine will

stop at the same time.

4 Engine oil minimum level indicator: this

warning light will light up to indicate that oil in the

engine has gone below the minimum level. A

safety system will kill the engine automatically to

prevent failures.

5 Engine startup failed: this warning light will

light up to indicate that the generating set has not

started up, after all four start-up attempts.

7 Change oil: this warning light will light up when

the engine has reached 100 running hours since

the latest oil change. Every time the oil is

changed, the After-sales service staff must reset

the timer to zero.

8 Fuel warning: this warning light will light up

when the fuel level inside the extra tank has gone

below its reserve level (about 4 litres)

9 Display time changeover switch: press this

switch to display the running hours since the lat-

est engine oil change.

10 Reset: this key (not visible) is used to reset

the panel (operation to be done only if the panel

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Telair Energy 2510b Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info