Bedienungsanleitung Traeger Pro 575 - 780 (Seite 22 von 28) (Englisch)

798655

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Following are frequently asked questions along with their answers:

QUESTION ANSWER

Why won’t

my grill

ignite?

Verify power at the electrical outlet. If the power cord is connected to a GFCI (ground fault circuit

interrupter), check and reset if necessary. Initiate start-up. If no ignition, see next answer.

DANGER! Turn the switch OFF (O) and disconnect the power cord. Remove the control and check the fuse

on back. Replace the fuse if blown. Reinstall the control.

Check the draf inducer fan and the auger drive motor for operation. If both are operating, the hot rod needs

to be replaced. If one or both are not operating, contact Traeger's VIP-365 Customer Service (see page 27)

for additional troubleshooting help or to place an order.

Verify that there are pellets in the pellet hopper. If this is the initial ﬁring or the grill has run out of pellets,

allow sucient time for the pellets to travel from the pellet hopper to the ﬁrepot (can take up to 7 minutes).

Initiate start-up. See “Using Your Grill” on page 13. If there are still no pellets in the ﬁrepot, proceed to next

answer.

If the auger drive motor is operating (check the small fan blade on the back of the motor), the problem

is in the digital control, which will need to be replaced. Contact your Traeger dealer or Traeger's VIP-365

Customer Service (see page 27) to place an order.

Why are

no pellets

being

delivered

into the

ﬁrepot?

If the auger drive motor is not operating but the draf inducer fan is operating, the problem is in the auger

system, which will need to be checked:

With the switch OFF (O), locate the small fan blade on the back of the auger drive motor.

CAUTION! While watching the fan blade, turn the switch ON (I). If the fan blade does not turn, turn the

switch OFF (O). This indicates a defective auger drive motor, and it will need to be replaced. Contact your

Traeger dealer or Traeger's VIP-365 Customer Service (see page 27) to place an order.

If the fan blade turns a bit and then stops, continue watching and turn the switch OFF (O). If the fan blade

unwinds slightly, this indicates a jam in the auger system, which will need to be cleared.

DANGER! Turn the switch OFF (O) and disconnect the power cord. Remove the pellets from the pellet

hopper. Check for foreign objects and wet or decomposed pellets, both of which can cause a jam in the

auger system. The auger will need to be removed to clear a jam in the auger system. See “How do I remove

the auger if it jams?” section on the following page.

Why is the

temperature

of my grill

ﬂuctuating?

Temperature ﬂuctuations are normal for Traeger grills. Any signiﬁcant ﬂuctuation could be the result of

wind, air temperature, improper use, or lack of grill maintenance.

FREQUENTLY ASKED QUESTIONS

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Traeger Pro 575 - 780 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Traeger Pro 575 - 780

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info