2. Note: Blade assemblies are interchangeable based on recipes and desired end results.
3. With the base unit on the tabletop and the unit plugged in, place the assembled travel cup onto the base and secure
into place.
4. For continuous blending, choose the desired speed (1or2).
5. To pause the blending process, rotate the speed button (P).
6. When you have finished blending, rotate the speed button to 0 modes. Remove the travel cup from the base. Unplug
the unit.
7. Turn cup right side up, turn blade assembly counterclockwise to remove. Attach travel cup lid by twisting clockwise.
Operating and Safety tips
Make sure the electrical outlet is rated at the same voltage as that stated on the bottom of the blender motor base.
Always use the blender on a clean, sturdy and dry surface.
Always operate the blender jar with the cover on. Place cover on firmly. Keep the blender jar cover on the blender jar
while blending.
Don’t put hands inside the blender jar when blender is plugged in.
Don’t remove blender jar or cups while unit is running.
Don’t place blade assembly onto motor base without the jar or cup attached.
Make sure blade assembly is tightly attached to jar or cups.
Always remove blade assembly before cleaning.
Don’t twist blade assembly from blender jar or cups when removing from motor base. Simply lift jar or cups from
motor base.
Use a rubber or plastic spatula as needed, only when the blender is turned off. Do not use any utensil inside the blender
while motor is on.
Never use metal utensils, as damage may occur to the jar, cup or cutting assembly.
Don’t store food or liquids in your blender jar.
Don’t overload blender jar or cups. If the motor stalls, turn the blender off immediately, unplug the unit and let it cool
for at least 15 minutes. Then, remove a portion of the food and continue.
Don’t blend hot liquids or carbonated beverages in chopper and travel cups.
Don’t use any container or accessories not recommended by standard accessories. Doing so may result in injury.
To remove jar or cup lift straight up. Do not twist to remove.
The jar, chopping cup and travel cups are not recommended for microwave use.
CLEANING AND MAINTENANCE
Always unplug your appliance from the electrical outlet before cleaning. The base and parts are made of corrosion-resistant
materials that are easy to clean. Before first use and after every use, clean each part thoroughly. Periodically check all parts
before reassembly. DO NOT USE if any part is damaged, or if the jar or cups are chipped or cracked.
To remove blade assemblies, twist off by turning counterclockwise.
NEVER TOUCH THE BLADE ITSELF.
CAUTION: Handle the blade assemblies carefully. They are SHARP and may cause injury. DO NOT attempt to remove blades
from cutting assembly.
Wash all parts in warm, soapy water; rinse and dry thoroughly. All parts are top rack dishwasher safe.
Tip: You may wish to clean your blending and chopper cutting assemblies as follows: squirt a small amount of dishwashing
liquid into blender jar or cups and fill halfway with warm water. Attach blade assembly. Run on 1 for 15 seconds. Repeat,
using clean tap water. Carefully disassemble parts and empty blender jar or cups. Rinse and dry all parts thoroughly.
