19
Installation instructions
Please fold out the page with diagrams!
Read the installation instructions prior to starting work and
follow them carefully!
Intended use
The Euro Mover has been built for use with single-axis
caravans with a gross weight of up to 1700 kg.
Installation using the standard installation kit is only possible
on caravans/trailers within the following dimensions.
all dimensions in mm
* With fully loaded vehicle
A distinction is made between L-profiled and U-profiled
chassis as shown in the illustration.
Measuring the chassis height
Chassis height (Y), measured at point (X)
X = 140 mm
Determining the installation type
1. Standard installation
Standard installation is used with an L-profile chassis and a
frame height (Y) of approx. 185 mm. No special accessories
are required.
2. Installation on a chassis with U-profile
Standard installation is used with a U-profile chassis and a
frame height (Y) of approx. 185 mm. A U-profile chassis kit
is needed to compensate for the profile edge.
3. Installation on a chassis with L-profile and frame
height of between 140 and 185 mm
With a chassis with a frame height (Y) of 140 mm to 185 mm,
1, 2 or 3 spacer plate sets and the U-bolt extension kit are
needed to compensate for the height.
4. Installation on a chassis with U-profile and frame
height of between 140 and 185 mm
The U-profile chassis kit, 1, 2 or 3 spacer plate sets and
the U-bolt extension kit are required to compensate for the
U-profile chassis edge and the height.
5. Installation on a chassis with L- and U-profiles with
frame height of less than 140 mm
On a chassis with a frame height (Y) of less than 140 mm a
low chassis kit must be fitted to compensate the height.
In Germany, the low chassis kit installation must be
accepted by a vehicle expert.
6. The AL-KO Vario III / AV installation kit must be used
with the AL-KO Vario III / AV chassis with a frame thickness of
less than 2.8 mm.
Special accessory installation
1. U-bolt extension kit
(for chassis with L-profile, frame height
from 140 to 185 mm)
U-bolts, nuts and washers,
Part. no. 60010-00100.
1.1. Spacer plate kit
(two 15 mm spacer plates)
for height compensation
max. 45 mm (3 plates) at each side
(e.g. installed behind axle)
Part. no. 60010-65000.
2. Low chassis kit
for height compensation for
caravan/trailer with frame height of
less than 140 mm,
Part. no. 60010-09400.
In Germany, this installation
kit must be accepted by a
vehicle expert.
3. U-profile chassis kit
(for chassis with U-profile,
frame height approx. 185 mm)
U-bolt with clamping plates and
self-locking nuts, stoppers,
Part. no. 60010-09200.
4. AL-KO Vario III / AV
Installation kit
for caravans with
AL-KO Vario III / AV Chassis
(frame thickness less than
2.8 mm) mandatory,
Part. no. 60010-21500.
5. Cross actuation device
(for swivelling both drive units
against the wheels from one
side and releasing them again)
connecting tube, middle tube,
nuts, bolts, grub screws,
Part. no. 60010-18500.
The Euro Mover is not approved for installation on
caravans/trailers with any other chassis! Any drilling
(exception: when using flat frame kit) or welding to the chassis
is not allowed. Under no circumstances remove any suspen-
sion components from the chassis.
