Bedienungsanleitung Venga VG SIS 2 (Seite 12 von 56) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

488163

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced

and folded in order to obtain a booklet A5 (+/- 148.5 mm

width x 210 mm height). When folding, make sure you

keep the good numbering when you turn the pages of

the I/B. Don’t change the page numbering. Keep the

language integrity.

VG SIS 2 - 101214

Assembly page 12/56

Fax +32 2 359 95 50

• Plug in the appliance and put the switch (1) in position “I” to switch it on. The power light

of the switch (1) and the pump pilot light (2) will light up, indicating that the appliance is

working and the iron is heating. Set the temperature dial of the iron (5) to the desired

position, the indicator lamp of the iron (8) will light up. As soon as the desired temperature

is reached, the pilot light of the iron will go out and you can start ironing.

• During ironing this pilot light (8) will come on from time to time. When this happens, the

soleplate is being heated up to the required temperature again. You can continue

ironing.

• The table is valid for the fibre materials only. If some kind of finish has been applied (gloss,

wrinkle, relief etc), the textile can best be ironed at a lower temperature.

First sort out the fabrics according to ironing temperature: wool with wool, cotton with

cotton, etc.

• The iron heats up quicker than it cools down. Therefore, start ironing the articles requiring

the lowest temperature such as those made of synthetic fibres. Then progress to the higher

temperatures.

• If the article is made of a mixture of different fibres, you must always select the lowest

ironing temperature of the composition of those fibres.

(E.g. an article consisting of “60% polyester and 40% cotton” should be ironed at the

temperature indicated for polyester and without steam.)

If you do not know what kind(s) of fabric(s) the article has been made of, find a spot,

which will be invisible when wearing or using the article to try out the ironing temperature.

(Always start at a low temperature and increase to one which gives the required results.)

• Pure woollen fabrics (100% wool) may be pressed with the iron set to a steam position. It is

recommended to apply shot-of-steam and use a dry pressing cloth.

When steam-ironing woollen fabrics, shining of the fabric may occur. This can be

prevented by turning the article inside out and ironing the inside or by interposing a light

damp cloth.

• Velvet and other textures that rapidly acquire shiny spots should be ironed in one direction

only (with the nap), applying only light pressure.

Always keep the iron moving.

• Iron the reverse side of synthetic materials and silk, it is not advisable to use steam as this

may cause stains.

FILLING WITH WATER (FOR STEAM-IRONING)

1. Put the base on a stable surface.

2. Use the small grips (4) of the water tank to take out the water tank. Open the cap (7) and

fill the water tank with clear water up to its "Max" level. Do not fill beyond this maximum

level! You can use tap water, but we advise you to use distilled water.

3. Close the cap (7) of the water tank.

4. Put the water tank back in the base correctly. Make sure to keep it upright in order to

avoid spilling water. Press the grips until the water tank is locked in place.

5. Never use vinegar, detergents or other chemical products.

FILLING THE WATER TANK DURING USE

As the water tank of this appliance is not under pressure, you can refill it during use. To do so,

switch off the appliance, unplug it and just proceed as described above in the "Filling with

water" section. When you have put the water tank back in place, plug the appliance in again,

switch it on and wait until the indicator lamp of the iron goes out. Then you can start ironing

again.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Venga VG SIS 2 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info