Bedienungsanleitung Venga VG SIS 2 (Seite 13 von 56) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

488163

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced

and folded in order to obtain a booklet A5 (+/- 148.5 mm

width x 210 mm height). When folding, make sure you

keep the good numbering when you turn the pages of

the I/B. Don’t change the page numbering. Keep the

language integrity.

VG SIS 2 - 101214

Assembly page 13/56

Fax +32 2 359 95 50

STEAM-IRONING

• Fill the water tank with water and insert the mains plug into a wall socket.

• As indicated on the temperature dial (5) and in the table, steam ironing is only possible at

higher ironing temperatures, so set the dial to  or .

• Put the switch (1) in ON position ("1") and set the temperature dial of the iron (5) to the

desired position. When the iron has reached the desired temperature, its pilot light (8) will

go out. You can now use the steam function.

• Turn the steam control knob (12) to regulate the amount of steam. Note: the maximal

steam rate (“MAX”) can only be used when the ironing temperature is higher than position

, or else water will drip from the sole.

• Press the steam button (6) to release steam from the soleplate of the iron. Release the

button and the steam will stop. If you want a continuous jet of steam, press the steam

button down and slide its transparent top part backwards so that the steam button locks.

To stop the continuous jet of steam, push the transparent part of the button forwards

again and release the steam button.

• When ironing, the pilot light of the iron (8) will go on and off from time to time. This means

that the temperature of the iron is regulated by its thermostat. You can continue ironing.

The pump pilot light will also go on and off, indicating that the steam pressure is being

regulated.

• When you use a lot of steam in a very short time, the steam output is lightly reduced until

your appliance produces enough steam to reduce the difference. This phenomenon also

happens when there isn’t enough water in the water tank.

• When the water tank is running empty, you will hear more noise when pressing the steam

button. If you want to go on using the steam function, you will have to refill the water tank.

STEAMING IN A VERTICAL POSITION

Position the temperature dial on its maximum level for vertical steam ironing. The steam rate

can be adjusted according to your needs.

You have to hang the cloth you want to smooth out avoiding the creases and place the iron in

a vertical position at a few centimetres from the piece of cloth. Then move the iron and press

the burst of steam button at the same time.

DRY IRONING

• Plug in the appliance and switch it on (power switch in position “I”).

• Use the temperature dial to set the temperature needed.

• When the indicator lamp of the iron goes out for the second time, you can start ironing.

• For ironing without steam, leave the steam control knob in OFF position and do not press

the steam button (6).

WHEN FINISHED IRONING

• We recommend cleaning the iron after use as follows: fill the water tank, put the

temperature dial on position “LINEN” and the steam regulator on MAX and let the iron

heat for 10 minutes. When the temperature has been reached, take the iron from the

base, hold it vertically and keep the steam button pressed for 30 seconds, then wait 30

seconds and repeat this cycle twice.

• Switch off the appliance (power switch in position “0”), unplug the appliance and let it

cool down.

• Empty the water tank.

• We recommend placing the iron on its base when you store it. The therefore foreseen

place is non-slip and will not damage the soleplate of the iron.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Venga VG SIS 2 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info