Bedienungsanleitung Visonic Powermaster-360 (Seite 60 von 96) (Englisch)

769323

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

60 D-307500 PowerMaster 360 Installer's Guide

Option

Configuration Instructions

upon reporting an alarm to the Monitoring Station. If the user disarms the system within that

cancel alarm time, a cancel alarm message is sent to the Monitoring Station indicating that the

alarm was canceled by the user.

Options: not active (default in USA); in 1/5 (default)/15/60 minute(s) and in 4 hours.

4.14.5 CP01 Setup

13:OPERATION MOD  CP01 SETUP

Enter the 04:CP01 SETU menu to configure its settings.

Option

Configuration Instructions

01:DISARM OPTION

Certain regulations require that when the system is armed in AWAY mode, it may not be

disarmed from the outside of the house (such as by keyfobs) before entering the protected

premises and activating an Entry Delay zone. To answer this requirement, the PowerMaster-

360 provides you with the following configurable options to disarm the system:

any time (default) – the system can be disarmed at all times from all devices.

on entry wrless – During entry delay, the system can be disarmed only using keyfob or

prox operated devices.

entry + away kp. – During entry delay by code, the system can be disarmed only using

PowerMaster-360 Virtual Keypad .

on entry all. – During entry delay, the system can be disarmed using keyfobs or by code

using the PowerMaster-360 Virtual Keypad.

03:END EXIT MODE

Define how the exit delay is terminated or restarted according to the following options:

restart+arm home (default) – During exit delay if the door was not opened, the alarm

system will be armed HOME instead of armed AWAY.

restart>reentry - Exit delay restarts when the door is reopened during exit delay. The restart

occurs once only. Restarting the exit delay is helpful if the user re-enters immediately after

going out to retrieve an item that was left behind.

door/fob/timer - When the door is closed, by pressing the AUX button on the keyfob1, or

when the exit delay has expired, whichever first.

fob/timer - By pressing the AUX button on the keyfob1, or when the exit delay has expired,

whichever first.

05:CONFIRM ALARM

Define a specific time period that if 2 successive alarms occur, the second alarm will be

considered as a confirmed alarm, (see RPT CNFM ALRM below).

Options: disable (default in USA); in 30/45/60(default)/90 minutes

07:RPT CNFM ALRM

Define whether the system will report a confirmed alarm.

report disabled (default) - The system will not report a confirmed alarm.

report enabled - The system will report a confirmed alarm.

08:ENTRY DELAY 1

09:ENTRY DELAY 2

Two different entry delays allow the user to enter the protected site (while the system is in

the armed state) via 2 specific doors and routes without causing an alarm.

Following entry, the user must disarm the control panel before the entry delay expires. Slow-

rate warning beeps start sounding once the door is opened, until the last 10 seconds of the

delay, during which the beeping rate increases. Locations No. 1 (entry delay 1) and 2 (entry

delay 2) allow you to program the length of these delays.

Options: 30 (default)/45/60 seconds; 3/4 minutes

10:ABORT TIME

The PowerMaster-360 can be configured to provide a delay before reporting an alarm to the

monitoring station (not applicable to alarms from FIRE, 24H SILENT, EMERGENCY, GAS

FLOOD and TEMPERATURE zones). During this delay period, the external siren will not

sound and the alarm is not reported. If the user disarms the system within the delay time, the

alarm is aborted.

Options: in 15 (default)/30/45 seconds

11:CANCEL ALARM

Define the cancel alarm period that starts upon reporting an alarm to the Monitoring Station.

Applies only when the keyfob is defined as skip exit delay (for further details, see the keyfob's User's Guide)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Visonic Powermaster-360 Seite 60

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info