Bedienungsanleitung Vonroc CR504AC (Seite 10 von 104) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch)

819185

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

WWW.VONROC.COM

Air loss

• May be caused by a poor seal of a connection.

• Check all air connections by wetting them with

a soapy water solution (Never use the solution

nearby electric connections).

• When the tank is empty and being ﬁlled. The

user might hear a sisseling sound by the pres-

sure switch. This is normal and will stop before

the compressor reach a pressure of 1.5 bar.

• Check if the drain cock (11) is closed well.

The compressor will not start

If the compressor is difﬁcult to start, check:

• Whether the voltage of the mains corresponds

to that on the speciﬁcation plate.

• Whether electrical extension cables are being

used with a faulty core or length.

• Whether the operating environment is too cold

(below 5°C).

• Whether there is electricity supply (plug properly

connected, magneto-thermal fuses not broken).

The compressor does not shut off

If the compressor does not shut off when the maxi-

mum pressure has been reached, the safety valve of

the tank will be activated. It is necessary to contact

the nearest authorised Support Service for the repair.

ENVIRONMENT

Faulty and/or discarded electrical or

electronic apparatus have to be collected at

the appropriate recycling locations.

Only for EU countries

Do not dispose of power tools into domestic waste.

According to the European Guideline 2012/19/EU

for Waste Electrical and Electronic Equipment and its

implementation into national right, power tools that

are no longer usable must be collected separately

and disposed of in an environmentally friendly way.

WARRANTY

VONROC products are developed to the highest

quality standards and are guaranteed free of

defects in both materials and workmanship for the

period lawfully stipulated starting from the date of

original purchase. Should the product develop any

failure during this period due to defective material

and/or workmanship then contact VONROC directly.

The following circumstances are excluded from this

guarantee:

• Repairs and or alterations have been made

or attempted to the machine by unauthorized

service centers;

• Normal wear and tear;

• The tool has been abused, misused or

improperly maintained;

• Non-original spare parts have been used.

This constitutes the sole warranty made by compa-

ny either expressed or implied. There are no other

warranties expressed or implied which extend

beyond the face hereof, herein, including the im-

plied warranties of merchantability and ﬁtness for

a particular purpose. In no event shall VONROC be

liable for any incidental or consequential damages.

The dealers remedies shall be limited to repair or

replacement of nonconforming units or parts.

The product and the user manual are subject to

change. Speciﬁcations can be changed without

further notice.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vonroc CR504AC Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info