Bedienungsanleitung Vonroc HA501AC (Seite 5 von 28) (Deutsch, Englisch, Holländisch, Französisch)

764012

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

WWW.VONROC.COM

4) Power tool use and care

a) Do not force the power tool. Use the correct po-

wer tool for your application. The correct power

tool will do the job better and safer at the rate

for which it was designed.

b) Do not use the power tool if the switch does not

turn it on and off. Any power tool that cannot

be controlled with the switch is dangerous and

must be repaired.

c) Disconnect the plug from the power source

and/or the battery pack from the power tool be-

fore making any adjustments, changing acces-

sories, or storing power tools. Such preventive

safety measures reduce the risk of starting the

power tool accidentally.

d) Store idle power tools out of the reach of child-

ren and do not allow persons unfamiliar with

the power tool or these instructions to operate

the power tool. Power tools are dangerous in

the hands of untrained users.

e) Maintain power tools. Check for misalignment

or binding of moving parts, breakage of parts

and any other condition that may affect the

power tool’s operation. If damaged, have the

power tool repaired before use. Many accidents

are caused by poorly maintained power tools.

f) Keep cutting tools sharp and clean. Properly

maintained cutting tools with sharp cutting

edges are less likely to bind and are easier to

control.

g) Use the power tool, accessories and tool bits

etc. in accordance with these instructions,

taking into account the working conditions and

the work to be performed. Use of the power tool

for operations different from those intended

could result in a hazardous situation.

5) Battery tool use and care

a) Recharge only with the charger speciﬁed by the

manufacturer. A charger that is suitable for one

type of battery pack may create a risk of ﬁre

when used with another battery pack.

b) Use power tools only with speciﬁcally desig-

nated battery packs. Use of any other battery

packs may create a risk of injury and ﬁre.

c) When battery pack is not in use, keep it away

from other metal objects, like paper clips,

coins, keys, nails, screws or other small metal

objects that can make a connection from one

terminal to another. Shorting the battery termi-

nals together may cause burns or a ﬁre.

d) Under abusive conditions, liquid may be ejec-

ted from the battery; avoid contact. If contact

accidentally occurs, ﬂush with water. If liquid

contacts eyes, additionally seek medical help.

Liquid ejected from the battery may cause

irritation or burns.

6) Service

a) Have your power tool serviced by a qualiﬁed

repair person using only identical replacement

parts. This will ensure that the safety of the

power tool is maintained.

ADDITIONAL SAFETY WARNINGS FOR HOT

AIR GUN

Before using the appliance check the following:

Make sure the voltage of the hot air gun

corresponds with the power voltage;

Are the mains lead and the mains plug

in a good state: strong, without ravels or

damages.

• Avoid the use of long extension cables;

• Do not use the appliance under moist circum-

stances;

• The metal mouthpiece gets hot. Watch out and

do not touch the metal mouthpiece;

• Prevent damage of the heating element. Do not

lock or block the mouth piece;

• Do not leave the appliance when switched on;

• Do not use the appliance for drying hair or for

drying living human beings in general;

• Do not use the appliance in a bath, above water

or in spaces where easy inﬂammable liquids are

used.

This appliance operates at a temperature of

600 degrees without visible signs of this

temperature (no ﬂames), still there is a

chance of ﬁre risk. Watch out for the hot air

stream from the mouth piece. This air

stream can cause burns.

When operating the appliance

• If you are going to use the hot air gun, vapours

and gas can be released during a short time.

This can be harmful for your health. Asthmatics

can suffer hindrance of it;

• Before connecting the plug to the mains voltage

you have to check if the switch is in position “0”;

• Keep the mains lead always away from the

mouthpiece of the hot air gun;

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vonroc HA501AC Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Vonroc HA501AC

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info