Bedienungsanleitung Webasto Pure II (Seite 13 von 379) (Alle Sprachen)

802209

Zoom out

Zoom in

Vorherige Seite

1/379

Nächste Seite

5110757E OI II Webasto Pure 1

1General information

1.1 Purpose of the document

These operating and installation instructions are part of

the product and contain information for the user to en-

sure safe operation and for the electrician to carry out

safe installation of the Webasto Pure charging station.

1.2 Using this document

u Carefully read the operating and installation instruc-

tions before installing and starting up the Webasto

Pure.

u Keep these instructions ready to hand.

u Hand these instructions on to the following owner or

user of the charging station.

NOTE

We would draw your attention to the fact that, as

part of a professional installation, an installation log

should be drawn up by the installer. We also request

that you fill in our Check list for the installation of the

Webasto charging station.

NOTE

Individuals with deficiency in their colour vision re-

quire support in the allocation of all fault indicators.

1.3 Intended use

The Webasto Pure charging station is designed for char-

ging electric vehicles in accordance with IEC 61851-1,

charge mode 3. In this charge mode, the charging station

ensures:

– The voltage is not applied before the vehicle has been

connected correctly.

– The maximum power is calibrated.

1.4 Use of symbols and highlighting

DANGER

This signal word denotes a hazard with a high degree

of risk which, if not avoided, may lead to death or ser-

ious injury.

WARNING

This signal word denotes a hazard with a moderate

degree of risk which, if not avoided, may lead to

minor or moderate injury.

CAUTION

This signal word denotes a hazard with a low degree

of risk which, if not avoided, will lead to minor or

moderate injury.

NOTE

This signal word denotes a Special Technical Feature

or (if not observed) potential damage to the product.

Requirements for the following necessary action

1.5 Warranty and liability

Webasto shall not assume liability for defects or damage

that are the result of the installation and operating in-

structions being disregarded. This liability exclusion par-

ticularly applies for:

– Improper use.

– Repairs carried out by an electrician not contracted by

Webasto.

– Use of non-original spare parts.

– Conversion of the unit without permission from .

– Installation and commissioning by unqualified staff

(not an electrician).

– Improper disposal after decommissioning.

2Safety

2.1 General information

The charging station has been developed, produced,

tested and documented according to the relevant safety

regulations and environmental requirements. The device

must only be used in a technically faultless condition.

Have any malfunctions that adversely affect the safety of

persons or of the device rectified immediately by an elec-

trician in accordance with nationally applicable regula-

tions.

NOTE

It is possible that the signalling in the vehicle differs

from that described here. Always read the operating

instructions of the respective vehicle manufacturer

and always observe these.

2.2 General safety information

– Hazardous voltages are present within the casing.

– The charging station does not have its own main

ON/OFF switch. The protective devices installed in

the power supply system are therefore also used

to disconnect the power supply.

– Check charging station for visual damage before

use. Do not use the charging station if damaged.

– Installation, electrical connection and initial opera-

tion of the charging station must only be carried

out by an electrician.

– Do not remove the cover of the installation area

whilst in operation.

– Do not remove markings, warning symbols and

the type label from the charging station.

– The charging cable must only be replaced by an

electrician in accordance with the installation in-

structions.

– It is strictly prohibited to connect other equip-

ment/devices to the charging station.

– When not in use, store the charging cable in the

designated holder and lock the charging coupling

in the charging station. Loosely wind the charging

cable around the charging station casing so that it

does not touch the ground.

– Make sure that the charging cable and coupling

cannot be driven over, trapped and are protected

from any other hazards.

– Immediately notify Webasto Customer Service if

the charging station, charging cable or the char-

ging coupling are damaged. Do not continue us-

ing the charging station.

– Prevent the charging cable and coupling from

coming in contact with external heat sources, wa-

ter, dirt and chemicals.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Webasto Pure II Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info