Bedienungsanleitung Yamaha CS2X (Seite 74 von 84) (Englisch)

48728

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

Appendix

1.2.23 RPN (Registered Parameter Number)

LSB (Control #100)

RPN (Registered Parameter Number)

MSB (Control #101)

Messages which offset, or add or subtract values from a Part’s pitch

bend sensitivity, tuning, or other parameter settings.

First send the RPN MSB and RPN LSB to specify the parameter

which is to be controlled. Then use 1.2.21 Data

Increment/Decrement to set the value of the specified parameter.

Note that once the RPN has been set for a channel, subsequent data

entry will be recognized as the same RPN’s value change. Therefore

after you use the RPN, you should set a Null (7FH, 7FH) value to

avoid an unexpected result.

The following RPN numbers can be received.

1.2.24 Channel Mode Messages

The following Channel Mode Messages can be received.

1.2.24.1 All Sounds Off (Control #120)

Clears all sounds currently sounding on the specified channel.

However, the status of channel messages such as Note On and

Hold On is maintained.

2nd BYTE 3rd BYTE MESSAGE

120 0 All Sounds Off

121 0 Reset All Controllers

123 0 All Notes Off

126 0 ~ 16 Mono

127 0 Poly

RPN MSB RPN LSB PARAMETER

00H 00H Pitch Bend Sensitivity

00H 01H Fine Tune

00H 02H Coarse Tune

7FH 7FH Null

NRPN MSB NRPN LSB

01H 08H

01H 09H

01H 0AH

01H 20H

01H 21H

01H 24H

01H 30H

01H 31H

01H 34H

01H 35H

01H 63H

01H 64H

01H 66H

14H rr

15H rr

16H rr

17H rr

18H rr

19H rr

1AH rr

1CH rr

1DH rr

1EH rr

1FH rr

24H rr

30H rr

31H rr

34H rr

35H rr

PARAMETER

Vibrato Rate

Vibrato Depth

Vibrato Delay

Low Pass Filter Cutoff Frequency

Low Pass Filter Resonance

High Pass Filter Cutoff Frequency

EQ Bass Gain

EQ Treble Gain

EQ Bass Frequency

EQ Treble Frequency

EG Attack Time

EG Decay Time

EG Release Time

Drum Low Pass Filter Cutoff Frequency

Drum Low Pass Filter Resonance

Drum EG Attack Rate

Drum EG Decay Rate

Drum Instrument Pitch Coarse

Drum Instrument Pitch Fine

Drum Instrument Level

Drum Instrument Panpot

Drum Instrument Reverb Send Level

Drum Instrument Chorus Send Level

Drum Instrument Variation Send Level

Drum High Pass Filter Cutoff Frequency

Drum EQ Bass Gain

Drum EQ Treble Gain

Drum EQ Bass Frequency

Drum EQ Treble Frequency

*rr=Note number for each drum voice instrument.

1.2.17 Portamento Control (Control #084)

Messages which apply a portamento between the currently-

sounding note and the subsequent note.

Portamento Control is transmitted specifying the note-on key of the

currently-sounding note.

Specify a Portamento Source Key number between 0 - 127.

When a Portamento Control message is received, the currently

sounding pitch will change with a Portamento Time of 0 to the next

note-on key on the same channel.

For example, the following settings would apply a portamento from

note C3 to C4.

90H 3CH 7FH C3 Note on

B0H 54H 3CH Source key number set to C3

90H 48H 7FH C4 Note on (When C4 is on, C3 is raised by a

portamento to C4.)

1.2.18 Effect1 Depth (Reverb Send Level)

(Control #091)

Messages which adjust the send level for the Reverb effect.

1.2.19 Effect3 Depth (Chorus Send Level)

(Control #093)

Messages which adjust the send level for the Chorus effect.

1.2.20 Effect4 Depth

(Variation Effect Send Level)

(Control #094)

Messages which adjust the send level for the Variation effect.

If Variation effect uses System effect, this message sets the send level

for the Variation effect. If it uses Insertion effect, this setting is

invalid.

1.2.21 Data Increment (Control #096)

Decrement (Control #097) for RPN

Messages which increase or decrease the MSB value of pitch bend

sensitivity, fine tune, or coarse tune in steps of 1. You are required

to assign one of those parameters using the RPN in the external

device in advance.

The data byte is ignored.

When the maximum value or minimum value is reached, the value

will not be incremented or decremented further.

(Incrementing the fine tune will not cause the coarse tune to be

incremented.)

1.2.22 NRPN

(Non-Registered Parameter Number)

LSB

(Control #098)

NRPN (Non-Registered Parameter Number)

MSB (Control #099)

Messages which adjust a voice’s vibrato, filter, EG, drum setup or

other parameter settings.

First send the NRPN MSB and NRPN LSB to specify the parameter

which is to be controlled. Then use 1.2.4 Data Entry to set the value

of the specified parameter.

Note that once the NRPN has been set for a channel, subsequent

data entry will be recognized as the same NRPN’s value change.

Therefore, after you use the NRPN, you should set a Null (7FH,

7FH) value to avoid an unexpected result.

The following NRPN numbers can be received.

cCS2x_App 12/10/98 5:15 PM Page 74

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha CS2X Seite 74

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha CS2X

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info