Bedienungsanleitung Yamaha MOTIF-RACK XS (Seite 107 von 118) (Englisch)

586891

107

Zoom out

Zoom in

Vorherige Seite

1/118

Nächste Seite

About MIDI

MOTIF-RACK XS Owner’s Manual

107

Basic Structure

Voice

MultiUtility

Reference

The Controls &

Connectors

Setting Up

Listening to

the Sound

Connections

Using a Computer

Quick Guide

Appendix

Reset All Controllers (Control #121)

The values of the following controllers will be reset to the

defaults.

All Notes Off (Control #123)

Clears all notes currently on for the speciﬁed channel. However,

if Hold1 or Sostenuto is on, notes will continue sounding until

these are turned off.

Mono (Control #126)

Performs the same function as when an All Sounds Off message

is received, and if the 3rd byte (mono number) is in the range of

0 – 16, it sets the corresponding channel to Mono Mode (Mode

4: m = 1).

Poly (Control #127)

Performs the same function as when an All Sounds Off message

is received, and sets the corresponding channel to Poly Mode.

■

Program Change

Messages that determine which Voice to select for each Part.

With a combination of Bank Select, you can select not only basic

Voice numbers, but also variation Voice bank numbers. For a list

of the Voices, see the separate Data List.

n When you specify a program change as a number in the range of 0 – 127,

specify a number that is one less than the program number listed in the

Voice List of the separate Data List booklet. For example, to specify

program number 128, you would actually enter program change 127.

■

Pitch Bend

Pitch Bend messages are continuous controller messages that

allow the pitch of designated notes to be raised or lowered by a

speciﬁed amount over a speciﬁed duration.

■

Channel Aftertouch

Messages which let you control the sounds by the pressure you

apply to the keys after the initial striking of the keys, over the

entire channel.

■

Polyphonic Aftertouch

This message is generated when pressure is applied to a key

after the note is played. Unlike the Channel Aftertouch event,

however, individual data is provided for each key.

System messages are the data related to the overall system of

the device.

■

System Exclusive Messages

System Exclusive messages control various functions of this

instrument, including master volume and master tuning, tone

generator mode, effect type and various other parameters.

General MIDI (GM) System On

When a “General MIDI system on” message is received, the

instrument will receive MIDI messages which are compatible

with GM System Level 1, and consequently will not receive Bank

Select messages. When the instrument receives the GM System

On, each receive channel of Parts 1 – 16 (in a Multi) will be

assigned to “1 – 16.”

F0 7E 7F 09 01 F7 (Hexadecimal)

n Make sure that the interval between this message and the ﬁrst note data of

the song is at least a quarter note or greater in length.

MIDI Master Volume

When received, the Volume MSB will be effective for the System

Parameter.

* mm (MSB) = appropriate volume value, ll (LSB) = ignored

F0 7F 7F 04 01 ll mm F7 (Hexadecimal)

Mode Change

When received, the mode of the MOTIF-RACK XS will be

switched.

* n = Device Number (page 100)

* m = 0 – 6, (0: Voice, 1 – 4: not used, 5: Multi, 6: Demo)

F0 43 1n 7F 03 0A 00 01 0m F7 (Hexadecimal)

■

System Realtime Messages

Active Sensing (FEH)

Once FEH (Active Sensing) has been received, if no MIDI data is

subsequently received for longer than an interval of

approximately 300 msec, this instrument will perform the same

function as when All Sounds Off, All Notes Off, and Reset All

Controllers messages are received, and will then return to a

status in which FEH is not monitored.

Timing Clock (F8H)

This message is transmitted with a ﬁxed interval (24 times per

quarter note) to synchronize connected MIDI instruments. You

can select whether this instrument uses the internal Timing

Clock, or external Timing Clock messages received via MIDI IN

by setting the MIDI Sync parameter: [UTILITY]

→

MIDI window

→

“MIDI Sync.”

CONTROLLER VALUE

Pitch Bend Change 0 (center)

Aftertouch 0 (off)

Polyphonic Aftertouch 0 (off)

Modulation 0 (off)

Expression 127 (max)

Hold1 0 (off)

Portamento 0 (off)

Sostenuto 0 (off)

Soft Pedal 0 (off)

Portamento Control Cancels the Portamento source key number

RPN Number not speciﬁed; internal data will not change

NRPN Number not speciﬁed; internal data will not change

System Exclusive Messages

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha MOTIF-RACK XS Seite 107

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha MOTIF-RACK XS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info