669113
66
Zoom out
Zoom in
Vorherige Seite
1/94
Nächste Seite
64
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |
PSR-2700 Digital Sampling
XPlay the Source and Adjust the Level ..................................................................................................
Play the sound you intend to record, via microphone or line, and adjust
the INPUT LEVEL control while watching the level indicators above the
control. The length of the “bar” formed by the level indicators increases as
input level increases. For optimum sound quality, your input signal should
cause most of the indicators to light, but not all. If all indicators including
the red “0 dB” indicator light in response to the input signal you’re prob-
ably overloading the input circuitry and will end up with distorted sound. At
the other extreme, if none of the indicators light, or only the lowest one or
two indicators light, then the input signal is too small and the level of the
recorded sound will be too low.
NOTES
• The keyboard and other function buttons will not operate in the level
check mode.
Setting the Sampling Frequency
The length of the sample you can record and its sound quality are determined by the “sampling frequency”. A
high sampling frequency produce better sound quality but shorter samples; a low sampling frequency allow
longer recording but with reduced sound quality. The PSR-2700 gives you two sampling frequency settings:
ZPress the [FREQ] Button .......................................................................................................................
Press the DIGITAL SAMPLING section [FREQ] button. The current
sampling frequency setting will appear on the LCD display panel.
XSelect a Frequency Setting ...................................................................................................................
Use the [+] and [–] buttons, the number buttons, the data dial, or the
[FREQ] button itself to select the desired sampling frequency setting
(“LOW” or “HIGH”).
NOTES
• The “LOW” setting is automatically selected when the PSR-2700
power is initially turned on.
08:Showtune 001:GrandPno
AccOff Frequency=1–:LOW
INPUT LEVEL
MIN MAX
0 dB
6
12
18
24
30
36
FREQ
021
–+
RESET
Setting Length Sound Quality
1: LOW 6 sec. (approx.) Low
2: HIGH 3 sec. (approx.) High
CExit ...........................................................................................................................................................
Once the input level has been set properly, press the DIGITAL SAM-
PLING [REC] button to exit from the level check mode.
REC
66

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yamaha PSR-1700 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info