Bedienungsanleitung Yamaha S30 (Seite 67 von 156) (Englisch)

586917

Zoom out

Zoom in

Vorherige Seite

1/156

Nächste Seite

Voice Mode

QED Filter (Quick Edit Filter)

These parameters control filters which affect the tonal

quality of the Voice. If you are using LPF (Low Pass

Filter) and HPF (High Pass Filter) combined together,

the parameters in the QED Filter page only affects LPF.

■Cutoff

Set the cutoff frequency. The frequency set here will be

a center frequency for signals to be filtered when they

pass through each filter.

❏Settings: -64 ~ 0~ +63

■Reso (Resonance)

Set the amount of Resonance (harmonic boost)

applied to the signal around the Cutoff frequency.

This is a useful way of adding further character to the

sound.

❏Settings: -64 ~ 0~ +63

QED EG (Quick Edit Envelope Generator)

These four parameters control the change in the output

level of a Voice over the time that a note is played.

■Attack

Set the transition time from the moment a key on

the keyboard is pressed to the point at which the

level of the Voice reaches its peak.

❏Settings: -64 ~ 0~ +63

■Decay

Set the transition time from the point at which the

level of the Voice reaches its peak to the point at

which it levels off.

❏Settings: -64 ~ 0 ~ +63

Key on Key off

Attack

Time Release

Time

Decay

Time

Level

Sustain

Level

QEDíEG) Attack Decay Sustain Release

C 1234 +63 +63 +63 +63

QEDíFilter) Cutoff Reso

C 1234 +63 +63

■Sustain

Set the level of the Voice maintained while the note

on the keyboard is being held down.

❏Settings: -64 ~ 0 ~ +63

■Release

Set the transition time from the point at which the

note on the keyboard is released to the point at

which the level of the Voice reaches zero.

❏Settings: -64 ~ 0~ +63

Common Arpeggio

The following four parameters control the behavior of

the Arpeggiator.

ARP Type (Arpeggio Type)

ARP Limit (Arpeggio Note Limit)

ARP Mode (Arpeggio Mode)

ARP PlayEF (Arpeggio Play Effect)

ARP Type (Arpeggio Type)

These are the basic parameters of the Arpeggiator.

■Type

Set the Arpeggio Type.

❏Settings: (see the separate Data List)

Sq (Sequence):

Creates a general arpeggio phrase. Mainly octave up/down phrases.

Ph (Phrase):

Creates more musical phrases than Sq. Starting with

“Techno,” there are phrases for a wide variety of musical

genres, and for creating backing tracks for guitar, piano and

other instruments.

Dr (Drum Pattern):

Creates drum pattern-type phrases. Phrase genres covered

include rock and dance. This Type is ideal for use with

drum and percussion sounds.

Ct (Control):

Creates tonal changes. No note information is created. The Key

Mode parameter in Arpeggio Mode must be set to “direct.”

■Tempo

Set the Arpeggio Tempo.

❏Settings: 25 ~ 300

[MIDI] is displayed here and the parameter cannot be

altered if MIDI sync is enabled (Page 131).

ARPíType) Type Tempo Switch Hold

C 1234 UpOct1:Sq 120 on on

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha S30 Seite 67

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha S30

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info