538895
72
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
72 GW13-014_v02
Hot water/steam
Ensure that the regulator knob (K) is in
position 0 and button is pushed in (M).
The turned off pilot light (N) indicates that
the espresso machine is ready to operate.
Ensure that the hot water/steam button
(B) is in the” pushed out” position . Then
the appliance is in the hot/boiling water mode.
Place the steam wand (C) inside the cup.
Warning: THE JUG/CUP WILL GET VERY
HOT DURING POURING.
Turn the regulator knob (K) into position .
Hot water will ow out of the steam wand (C).
The standby light (N) is illuminated during this
process.
When a sufcient amount of water has been
obtained, turn the regulator knob (K) into
position 0. Remove the cup or dish from
under the steam wand (C).
Warning: When the brewing has been
completed and the regulator knob (K) is in
position 0, excess steam under pressure
may be released into the drip tray. It is
normal.
Cleaning
Remove the grid (J) and the drip tray (I).
Clean these part in warm water with washing-
up liquid. Do not wash in a dishwasher as it
may deform these parts.
If the inner part of the rim of the lter is partially
or completely covered with ground coffee, clean
it by owing part or all of the water tank content
through.
PREPARING THE ESPRESSO MACHINE FOR ITS FIRST
USE (DESCRIPTION)
1. Place the espresso machine on a dry and stable surface.
2. Check that the drip tray (I) and the grid (J) are in place.
3. Fill up the water tank with water.
There are two ways of lling the tank up with water:
a) Lift the lid of the water tank; it is in the top part of the espresso
machine and using e.g. a jug, ll it up with fresh cold water or
with ltered water and close the lid.
b) Alternatively, the water tank can be taken out and lled up with
fresh cold water. To do this, lift the lid and using it as a handle,
slide the water tank out. Next, ll it up with fresh cold water or
with ltered water (1). Replace the water tank and close the lid.
Warning: Before turning the espresso machine on, check that the
regulator knob (K) is in position 0 (off) (2).
4. Plug in the connecting cord into a 230 V alternating current mains
socket. Press button (M) to turn on the espresso machine (3). Turn
on the espresso machine by pressing button (M). The pilot light (L)
will illuminate in red, whereas the standby pilot light will start ashing.
When the espresso machine is ready to operate, the standby pilot
light (N) will come off.
Warning: Remember that if the standby pilot light (N) ashes, it
indicates that the espresso machine has not reached the right
temperature for operation.
Notice: When using the appliance for the rst time of when it has not
been in used for a longer period of time, it is particularly important that
the espresso machine is rinsed.
5. To do this, place a lter for one or two cups in the holder (H). lace the
lter holder (E) in the brew head (6).
Place a sufciently large container under the two lling outlets (7).
Check that the espresso machine is in the espresso mode, that is
that button is pushed in (M) (the on/off light is illuminated (L)) and
the hot water/steam button (B) is in the “pushed out” position
(the standby pilot light (N) is off).
7. Turn the regulator knob (K) anticlockwise (8) into the espresso position
and allow the water to ow until the whole container has been
emptied. The standby light (N) is illuminated during this process.
BREWING ESPRESSO (DESCRIPTION)
Before starting preparations for brewing coffee, check that the espresso
machine is in the espresso mode, i.e. that the red power light (L) is on and
the standby light (N) comes off.
To obtain a avour-rich coffee, the cups, the lter holder and the lter may
be pre-heated in the following manner:
Pre-heating the lter holder (E) with the ler (H)
1. Fill up the water tank with cold water (1) and turn on the appliance (3).
2. Select a suitable lter (H) and place it in the holder (E) (4)
Tip: Use a smaller lter (for one cup) for one coffee, and a bigger one
for two coffees.
72

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Zelmer Piano 13Z014 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info