When backup starts, the disk number and the indication
"wait..." appear on the display.
When the project size is larger than the capacity of one ZIP
or MO media volume, the disk will be ejected after it has
been filled up, and a message prompting the user to insert
the next ZIP or MO disk appears.
10.
When the above message appears, insert a new
ZIP or MO disk, and press the [ENTER] key.
The backup operation resumes. The new disk number and
the indication "wait..." appear on the display.
To cancel the operation, press the [EXIT] key to bring up
the indication "CANCEL?" on the screen, and then press
the [ENTER] key.
• When a backup spans several media volumes, be sure to
note the disk number on the case and label.
• During restore, ZIP or MO disks must be inserted in the
same order as during backup. Otherwise correct restore
is not possible.
11.
Repeat the above steps until the entire project is
backed up.
When the backup is finished, the display indication
changes to "SAVE COMPLETE".
12.
To return to the main screen, press the [EXIT] key
several times.
Storing all projects on external
media (backup of entire hard
disk)
You can copy the entire contents of the hard disk in the
MRS-1044 series to an external SCSI device.
If a project does not fit onto disk (or other form of media),
the project will be copied onto separate volumes that will
begin with lower numbers.
When backing up the entire hard disk, a directory named
"PROJxxx" (where xxx is the project number) will be
created on the backup target for each project. Proceed with
care, because any existing directory on the target with the
same name will be overwritten.
1.
When an external SCSI device is used as backup
target, verify that the device is connected to the
MRS-1044 series and turned on.
2.
When using a CD-R/RW drive, MO drive, or ZIP
drive, insert a suitable media into the drive.
3.
In the main screen, press the [PROJECT/UTILITY]
key.
4.
Use the cursor [
E
]/[
R
] keys to make the display
indicate "UTILITY BACKUP", and then press the
[ENTER] key.
If the above menu does not appear, the MRS-
1044 has not properly recognized the SCSI
device. Check the power on/off condition of the
drive and the SCSI connection.
5.
Use the cursor [
E
]/[
R
] keys to make the display
indicate "BACKUP AllSave", and then press the
[ENTER] key.
If the unit detects that both a CD-R/RW drive and another
SCSI device are connected, a screen to select the backup
target appears when you press the [ENTER] key in step 5.
6.
Use the cursor [
E
]/[
R
] keys to select "CD-R/RW"
(to back up to the CD-R/RW drive) or "ExtDRV" (to
