Bedienungsanleitung American Audio Q-2422 PRO (Seite 12 von 22) (Englisch)

603204

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

©American Audio® - www.AmericanAudio.com - Q-2422 PRO User Instructions page 12

Q-2422 PRO REAR PANEL - CONTROLS AND FUNCTIONS

27. GND (GROUND TERMINAL) - Be sure to connect turntable ground leads to either or both of the

two available ground terminals. This will reduce the humming and popping noises associated with

magnetic phono cartridges.

28. MICROPHONE 2 CONNECTOR - This jack is used to a connect a microphone to the mixer.

Connect you microphone via this 1/4 inch (6.3mm) jack. The volume output level for this

microphone

will be controlled by its own respective VOLUME KNOB (24).

29. MIC ATTENUATOR - This knob is used to adjust the MIC 1 and MIC 2 input level.

30. CHANNEL LINE LEVEL SELECTOR SWITCHES - These switches are used to change the volt

age line levels of there respected Phono / Aux RCA inputs jacks. When connecting turntables with

magnetic cartridges to these jacks be sure the corresponding switch is in the “PHONO” position,

and when using line level input devices be sure this switch is in the “AUX” position. Always be sure

main power is shut off before change the position of the Line Level Selector Switch.

31. CHANNEL 1: PHONO 1/AUX 1 INPUT - The type of input must directly reﬂect the selected mode

of the LINE LEVEL SELECTOR SWITCH (30). Turntables equipped with MM pickup cartridge (All DJ

turntables use MM pick-up cartridges) may be connected to these jacks as long as the LINE LEVEL

SELECTOR SWITCH (30) is in the “PHONO 1” position. CD players, Tape Decks and other line level

instruments may only be connected to these jacks as long as the LINE LEVEL SELECTOR SWITCH

(30) is in the “AUX 1” position. Never connect line level instruments (CD players, tape decks, etc.)

to these jacks when the LINE LEVEL SELECTOR SWITCH (30) is in the “PHONO 1” position, THIS

MAY SERIOUSLY DAMAGE YOUR MIXER! The red colored RCA jack represents the right channel

input and the white represents the left channel input. Input volume will be controlled by the channel

one fader. The channel SOURCE SELECTOR SWITCH (3) must be in the "Phono 1/Aux 1" position,

to monitor any source connected to these jacks.

CHANNEL 1: LINE 1 INPUT JACKS - DO NOT CONNECT TURNTABLES TO THESE JACKS!

CD players, Tape Decks and other line level instruments may be connected to these jacks. The red

colored RCA jack represents the right channel input and the white represents the left channel input.

Input volume will be controlled by channel one fader. The channel SOURCE SELECTOR SWITCH (3)

must be in the "Line 1" position, to monitor any source connected to these jacks.

32. CHANNEL 2: PHONO 2/AUX 2 INPUT - The type of input must directly reﬂect the selected mode

of the

LINE LEVEL SELECTOR SWITCH (30). Turntables equipped with MM pickup cartridge (All DJ

turntables use MM pick-up cartridges) may be connected to these jacks as long as the LINE LEVEL

SELECTOR SWITCH (30) is in the “PHONO 2” position. CD players, Tape Decks and other line level

instruments may only be connected to these jacks as long as the LINE LEVEL SELECTOR SWITCH

(30) is in the “AUX 2” position. Never connect line level instruments (CD players, tape decks, etc.)

32 30 31 30 2841 40 39 38 37 36 35 34 33 29

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

American Audio Q-2422 PRO Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von American Audio Q-2422 PRO

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info