Bedienungsanleitung Corally SP12X (Seite 23 von 28) (Englisch)

639717

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Ride height adjustm ent.

The ride height sh o u ld be kept to a minimum, th is will keep th e centre of gravity of th e car as low as

possible and so maximise cornering speeds. The ride height sh o u ld ideally be betw een 3  5 mm

(1/8"-3/16"), but on bum py tracks or where re gu lations dictate otherw ise ru n th e car a little higher.

Check re g u larly to com pensate for tire wear which can be

ra p id on so m e tracks.

Adjusting th e fro n t ride height.

Each fro n t ste e ring block is su p p o rte d by alum inium washers. Placing th e se under th e steering block

low ers th e chassis (less ride height) and conversely putting th e m above ra ise s th e ch a ssis, giving

more ride height.

Adjusting th e re ar ride height.

Three diffe re n t pairs of re a r axle bearing holders have been included in th

e kit, th e y are all off-set

to give 6 diffe re n t re a r axle height se ttings. Rem ove th e re a r axle and fit th e appropriate pair of

bearing holders to each end of th e re a r axle tu b e , com plete with ball bearings and put th e re a r axle

back into place. Do not fo rg e t to re -mesh your pinion and sp u r gear. Always use th e sa m e height

se tting on both sides of th

e car otherw ise th e re a r axle bearings will lock up.

Front dam per se rvicing.

Your Corally car fe a tu re s an o-ring dam ping syste m inside the fro n t sp rings. This syste m provides a

su p e rb ly sm o o th dam ping action. To se rvice th e se dam pers re m o ve th e fro n t sp rings and clean th e

dam per p osts and o-ring collars. Then add new dam per syru p around th e dam per p o sts and th e o-ring

inside th e collars.

Rear tu b e dam per se rvicing and adju stm e n t.

The re a r tu b e dam pers are a very im p o rta n t part of th e car. These dam pers control th e re a r

su sp e n sion movement.

Periodically check th a t th e movement of th e se dam pers is even and sm ooth in all dire ctions. To

change th e dam per action (stiffness) th e dam per syrup has to be re p laced by another typ e . Corally

o ffe rs 3 diffe re n t grades as fo llow ing:

#80000  Dam per Syrup, Soft

#80001  Dam per Syrup, Hard

#80002  Dam per Syrup, X-Hard

Rear dam per se tu p .

e re a r dam per se tup co n tro ls th e sp e e d at which th e re a r suspension moves over bum ps and

th ro u gh tu rn s.

- If th e car is poor over bum ps th e n increasing th e re ar dam pening effect may help.

- Increasing th e re a r dam pening effect will also increase stee ring a little, remember th is when

making th is adju stm e n t for other re a so n s.

- If th e inside fro n t wheel goes light or even lift

s during cornering th e n th e dam per is to th in.

- If th e car is re luctant to change dire ction quickly enough in chicanes th e n re d u cing th e re a r

dam per effect may help.

General ru le - if th e car understeers whilst exiting corners th e n th e re a r dam per is se t to o th in. If

th e car o ve rste e rs exiting corners th e n th e dam per is to o th ick.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Corally SP12X Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info