Bedienungsanleitung Dik Geurts Vidar Triple-wall (Seite 33 von 76) (Deutsch, Englisch, Holländisch, Französisch)

695365

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

English

INSTALLATION MANUAL

!Tip

When replacing the glass pane always replace the glass pane seal in the door (= seal between the glass pane and

the door) AND the door seal (= seal between the door and the fire).

9.4.1.2 Disassembly of side panes

The side panes must be replaced in case of cracks or fractures in the glass pane.

Unscrew the Allen screw (see Annex 2, fig. 11).

Now follow the steps described in paragraph 9.4.1.1 ‘Disassembly of glass pane in door’.

!Caution

The side panes are made of IR glass. This glass consists of a coating that reflects a large part of the infra red

radiation (heat radiation). This glass is characterized by a rough (coating) and smooth side. It is very important that

the side panes are mounted with the coated side towards the outside.

!Tip

Mark the coated side of the side panes before disassembling the side pane. This will help you to place back the

side panes correctly.

9.4.2 Assembly of glass panes

9.4.2.1 Assembly of glass pane in door

Assemble the glass pane in the door according to the steps described in paragraph 9.4.1.1 ‘Disassembly of glass

pane in door’, only in reverse order.

!Caution

- Do not fasten the bolts too tight to avoid breaking off and/or stripping: overtightening will cause breakage.

- Place the glass pane (including new pane seal) with the logo to the bottom right.

- Place a new door seal.

- Slide both ends of the door seal in the supplied sleeve (see Annex 2, fig. 10).

!Caution

Make sure that the sleeve is placed on the underside of the glass pane.

9.4.2.2 Assembly of side panes

For assembly of the side panes, please observe the instructions provided in paragraph 9.4.1.2 ‘Disassembly of side

panes’, only in reverse order.

!Caution

Properly press down the side doors during assembly, before the Allen screws are tightened again! The side doors

must fit onto the appliance properly, in order to prevent leakage and attraction of false air.

!Caution

Mount the panes with the rough (coated) side towards the outside (see 9.4.1.2).

9.5 Supplementary installation instructions per appliance

9.5.1 Vidar Wall

9.5.1.1 Placing the appliance

This appliance should be installed as suspending from a wall.

!CAUTION

The Vidar Wall should only be mounted to a vertical wall made of solid, non-combustible and heat resistant

material.

!Caution

The flue exhaust (niche pipe or connecting piece suitable for stainless steel pipe 150 mm) in the ceiling should be

190 mm from the wall, measured from its centre. In all other cases, you must use bends.

When placing the fire, please proceed as follows (see Annex 2, fig. 12):

Mount the wall plate. The recommended height is 930 mm (A), measured from the top of the wall bracket

(= 450 mm (B) from the bottom of the appliance to the floor)).

!Caution

When attaching the wall plate, maintain aminimumheight of 780 mm (A) (= 300 mm (B) from the bottom of the

appliance to the floor))!

Attach the wall plate with the supplied key sleeves and key bolts. Make sure everything is mounted level and that

the wall plate is centrally located under the flue exhaust in the ceiling.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dik Geurts Vidar Triple-wall Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Dik Geurts Vidar Triple-wall

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info