Bedienungsanleitung Elro HA68S (Seite 9 von 34) (Englisch)

536725

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

-7--58-

A LED indicator F Key Chain Ring

B Arm G Battery Cover

C Partial Arm H Negative Polarity

D Disarm I Positive Polarity

E Panic Switch

The Remote Control Unit is used to Arm, Partial Arm and Disarm the system.

The Remote Control also incorporates a Panic switch. Activating the Panic switch

will immediately initiate a Full Alarm condition whether the system is Armed or

Disarmed, (unless the system is in Service, Test or Program mode).

The Remote Control adopts a CR2032 type Lithium cell which under normal

conditions will have typical life in excess of 1 year. Under normal battery

conditions the LED on the Remote control will only illuminate when a button is

pressed. However, under low battery conditions this LED will flash every time

the button is pressed. When this occurs the batteries should be replaced as

soon as possible.

SETTING THE REMOTE CONTROL

1.Remove the rear cover by undoing the small screw on the rear of the Remote

Control.

2.Insert the battery ensuring that the +v terminal faces upwards away from

the PCB.

REMOTE CONTROL UNIT

Front Back

CHIME

The Chime facility can only be operated with the system in Disarm mode.

Press to toggle the Chime facility between ON and OFF.

Note: If the Chime is ON and the system is then armed the Chime will remain

ON after the system is disarmed.

MUTE

The Mute facility can only be operated with the system in Disarm mode.

Press to toggle the Mute facility between ON and OFF.

Note: If the Mute is ON, no voice guidance will be made during operation. If the

mute is OFF, voice guidance will be active. However, if ‘LINE STATUS’ LED

illuminates while the mute is OFF, there is no voice guidance will be available.

LATCH KEY

Press to access the latch key function for quick programming.

EVENT-LOG

The Event Log will store the last 50 system Arm, disarm, alarm and detector

Low Battery events. The Event Log will record the time, date and details for

each event. If when the system is disarmed the “ALARM MEM’ LED is flashing

and the panel beeps every 10s, this indicates that an alarm has occurred. To

cancel the LED and stop the beeping you must access the event log or press

to eliminate the flashing ‘ALARM MEM’ LED and the beeping as well.

To access the Event Log, (with the system in Disarm):

Press .

The Event-Log will automatically start scrolling through and displaying the event

data starting with the most recent event. The data for each event is shown on

two screens, each screen will be displayed for 5 seconds before moving on to

the next screen and then the next event.

Use the and buttons to manually scroll through the event log to the

required position as necessary.

Press to return to Disarm.

TELEPHONE LINE DETECTION

When setting to the voice dialer and If ‘LINE STATUS’ LED is flashing, it implies

bad telephone line connection or telephone network being out of order. Check

the telephone line and re-test it.

When setting to the digital dialer and if ‘LINE STATUS’ LED is flashing, it implies

two causes of failure. One is bad telephone line connection or telephone

network being out of order. The other cause of failure is derived from the

central monitoring station. Consult with the central monitoring station for help.

ENEN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elro HA68S Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Elro HA68S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info