Bedienungsanleitung Elro HA68S (Seite 10 von 34) (Englisch)

536725

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

-57--8-

CONTROL PANEL

3. Replace the rear cover and fixing screw.

4. In order to communicate with the Control

Panel, the ID code of the Remote Control needs

to be learned by the Control Panel. By pressing

the button on the Remote Control will emit

the ID code to the Control Panel instantly,

subject to the Control Panel being set at the

User Setup mode.

LOCATING THE CONTROL PANEL

When choosing a suitable location for the Control Panel, the following points

should be considered.

1. The Control Panel should be located in a position out of sight of potential

intruders and in a safe location, but easily accessible for system operation.

2. The Control Panel should be mounted on a sound flat surface to ensure that

the rear tamper switch on the Control Panel is closed when the Panel is

mounted. The Control Panel should be mounted at a convenient height of

between 1.5 and 2m and in a position where it will be seen each day.

Note: If small children are in the household, a further consideration should

be given to keeping the units out of their reach.

3. It is recommended that the Control Panel should be positioned such that the

Exit/Entry tone (emitted by the Control Panel) can be heard from outside the

property.

4. The Control Panel should be mounted within a protected area so that any

intruder cannot reach the Control Panel without opening a protected door or

passing through an area protected by a PIR detector when the system is

armed.

5. The Control Panel must be located within reach of a mains socket.

6. If the telephone based functionality is to be used then the Control Panel will

need connecting to a convenient telephone point.

Note: It is recommended that the telephone connection lead is not extended

beyond 5m before connecting to a telephone master or secondary outlet.

7. Do not locate the Control Unit closer than 1m to any large metallic object,

(e.g. mirrors, radiators, etc) as this may affect the radio range of the Control

Panel.

Batterij

Remote Control:

Press the ‘DISARM’ button, .

Control Panel:

User Password

If the system is disarmed and the ‘ALARM MEM’ LED is flashing with the panel

beeping every few seconds, this indicates that an alarm condition has occurred.

Use the Event Log to find out and make a note of where the alarm occurred to

assist in tracing the cause of the alarm.

QUICK SET

To operate the quick set function and fully arm the system in 5s, overriding the

programmed exit delay. Press:

User Password

PANIC ALARM

A full Alarm condition can be immediately initiated

at any time (whether the system is Armed or Disarmed) in the event of threat

or danger by activating a Panic switch on either the Remote Control or the

Control Panel.

Remote Control:

Slide the Panic switch upwards.

Control Panel:

Press and hold the button for approximately 3 seconds.

The alarm will continue either for the alarm duration when the system will

automatically reset or until the system is disarmed.

TAMPER

If the battery cover of any device is removed or if the Siren or Control Panel are

removed from the wall then a Full Alarm condition will be initiated even if the

system is Disarmed. The alarm condition will continue either for the alarm

duration when the system will automatically reset or until the system is

Disarmed. The ‘ALARM MEM’ LED on the Control Panel will flash and the panel

will beep every few seconds to indicate an alarm has occurred.

Note: The Tamper protection facility on the Siren operates independently. If the

Tamper on the Siren is activated this will not be indicated at the Control Panel.

ENEN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elro HA68S Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Elro HA68S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info