Bedienungsanleitung Elro HA68S (Seite 19 von 34) (Englisch)

536725

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

-17--48-

For double security, there are two tamper switches fitted on the Detector.

(FIGURE 2) Either removing the Detector from the protected door/window or

removing the battery cover will generate a full alarm condition.

The Magnetic Contact Detector is of self-contained wired Magnetic Contact. This

contact must be of a normally closed contact type with the contacts being

opened in order to generate an alarm condition.

CHOOSING A MOUNTING LOCATION

The Magnetic Contact Detector is suitable for mounting in dry interior locations

only.

Decide which doors/windows are to be protected by Magnetic Contact Detectors,

(usually the front and back doors as a minimum will have Magnetic Contact

Detectors fitted). Additional detectors may also be fitted where required to other

vulnerable doors or windows, (e.g. garage, patio/conservatory doors etc).

Note: Take care when fixing the Detector to a metal frame, or mounting within

1m of metalwork (i.e. radiators, water pipes, etc) as this could affect the radio

range of the device. If required, it may be necessary to space the magnet and

detector away from the metal surface using a plastic or wooden spacer to

achieve the necessary radio range.

INSTALLING THE MAGNETIC CONTACT DETECTORS

Ensure that the system is in Test Mode.

1. Undo and remove the fixing screw from

the bottom edge of the Detector.

Remove the battery cover by sliding

and lifting it off. (DO NOT use a screw

driver to lever the cover off).

2. Fit the 3.6V Lithium battery supplied,

with the negative (-) towards the

battery spring.

3. Mount the Detector to the fixed part of the frame along the opening edge

opposite the hinges using either the double sided adhesive tape or screws

provided.

If fixing the Detector with screws; fit the Keyhole slot in the top of the

Detector over the head of the smaller pan-head screw. Secure the bottom of

the Detector using the 12mm countersunk head screw fitted within the

battery compartment. You will need to drill out the centre of the fixing screw

hole using a 3mm drill. Do not over tighten the fixing screws as this may

distort or damage the casing.

4. Fit the Magnet to the moving part of the door/window opposite the Detector

using the adhesive tape or 15mm fixing screws.

Ensure that the parallel gap between the Magnet and Detector is less than

10mm and that the arrow on the Magnet is pointing towards and aligned with

the mark on the Detector.

Battery Cover

Scroll through the programming menu until ‘5. FULLY ARM’ is displayed and

press .

Note: After configuring fully arm press to return to the top level

programming menu.

EXIT DELAY

Default setting: ON 30s

Scroll through the menu until ‘5-1 Exit Delay’ is displayed. The current setting

will also be displayed.

To change the setting press .

Press to enable the Exit delay and enter the required exit delay period

(1-250s), or

Press to disable the Exit delay.

Press to save and exit, or

Press to exit without saving.

Press to return to top level fully arm setup menu.

ENTRY DELAY BEEP

This controls the warning beep which operates during the Entry Delay period

when Full Arm is active.

FULLY ARM SETUP

PROGRAM MODE

Code:

5. FULLY ARM

5-1 Exit Delay

xx xxx SEC

Select

ON->* OFF->#

Input

(1-250) Secs.

Select

ON->* OFF->#

5-2 Entry Delay

Beep: xxx

Select

ON-> OFF->#

5-3 Exit Delay

Beep: xxx

ENEN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elro HA68S Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Elro HA68S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info