The heating symbol will disappear and re-appear accordingly.
If no button is pressed during two (2) minutes, the ambient temperature will disappear
from the display. Pressing any button will make the ambient temperature re-appear.
Setting the time and day on the heater using the control panel
Using the M button, the time and day of the week can be entered so that you can use the
timer function.
The heating panel should be ON, but should NOT heat and therefore, there is no heating
symbol visible on the display. (Do this by setting the temperature lower than the ambient
temperature, for example.)
Checking the day / time data on the heater using the control panel
The heating panel should be ON and should heat. Therefore, the heating symbol is visible
on the heater’s display. (Do this by setting the temperature higher than the ambient
temperature, for example.)
Briefly and consecutively press the M button on the heater’s control panel in order to
check the day and time: HH = day of the week, H1 = hour and H2 = minute
Attention: If the infrared panel is switched OFF using the main switch or by removing the
plug from the socket, the day will be set to 1 and the time to 00.00 the next
time you switch the heater ON again.
Operation with remote control
Operation using the remote control
The remote control should be directed towards the display in order to operate the heating
panel using the remote control. The illustration shows the position (IR) of the reception
point of the remote control.
1. Turn the main switch on the heater ON.
The symbol indicating the capacity lights up and the WiFi symbol flashes on the
heater’s display. When the WiFi symbol flashes, you can make a connection (please
refer to the end of this instruction booklet).
