Bedienungsanleitung Fagor CAT 44NG (Seite 28 von 104) (Englisch, Französisch, Portugiesisch, Spanisch)

485594

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

14 What do I do, if ...

13.8 Cleaning the steam valve

• ... coffee-making is interrupted and

«REFILL WATER» is displayed?

– The water tank is empty: Refill the

water tank and press the „OK“ key

(Fig. 3, g).

• ... coffee-making is interrupted and

the indications «CLEAN

BREWING UNIT» and

«SWITCH OFF UNIT» are shown

alternately?

– Brewing unit is overfilled: Carefully

clean the brewing unit; see

„Cleaning the Coffee-making Unit“.

– In powder mode spoon in a max. of 2

• ... the machine can no longer be

operated and «WASTE CONTAI-

NER» is indicated?

– Container is full: Empty container

and clean thoroughly; see „Emptying

the Container“.

– In powder coffee mode, fill in max. 1

measuring spoon of coffee powder.

– Adjust to a lower grinding level: see

“Changing grinding quantities”.

– Check the ejection lever: see

Cleaning the brewing unit”

Clean the frothing unit as well as the

steam valve after frothing or heating

up milk. If the steam valve allows only

a reduced amount or no steam or hot

water to pass through, we recommend

decaling in addition.

Caution! Risk to health through milk

residue on the frothing unit and

steam valve! Contamination through

dried milk on the frothing unit as well

as the steam valve is a breading

ground for bacteria. Keep these parts

of the appliance clean at all times.

Caution! Risk of burning on the

frothing unit and steam valve! The

frothing unit as well as the steam valve

get very hot during the frothing

of milk or the preparation of hot water,

and can cause burns. Allow these

parts of the appliance to cool down

before starting cleaning. Only hold the

frothing unit by the black cap.

Method:

Remove the frothing unit and rinse off

the milk residue under flowing water.

Subsequently wipe the steam valve

with a damp cloth. Fig. 43

Clean the air suction opening of the

frothing unit if blocked by poking the

clogged opening carefully with a

pointed needle. Fig. 44

Now unscrew the outlet valve from the

steam valve. For this, use the measu-

ring spoon P with the integrated took

function. Fig. 45

Clean the outlet valve by poking the

clogged opening carefully with a

pointed needle.

Then rinse thoroughly and check that

the valve is free. Fig. 46

To clean the steam valve, place a

container under the steam valve. Turn

rotary switch D “Hot water/steam” into

position and allow hot water to pass

through briefly without the screwed-

on outlet valve. This rinses out any

remaining contamination from the

steam valve.

Now screw the cleaned outlet valve

back onto the steam valve using the

measuring spoon P. Fig. 47

Then again place the frothing unit

onto the steam valve and lock. Fig. 48

Caution, protection of the applian-

ce! A clogged steam valve can damage

the appliance! If the steam valve still

does not let through any steam or hot

water following cleaning of the outlet

valve, the device must be descaled.

Corresponding information can be

found in the chapter “Starting the

descaling programme”.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Fagor CAT 44NG Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info