Bedienungsanleitung Honda HRX537 HYEA (Seite 16 von 23) (Englisch)

580898

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

ENGLISH

Blade Removal

1. HYEA: Put the throttle lever in the STOP position.

HZEA: Turn the key to the OFF position.

2. Disconnect the spark plug cap. Tilt the mower to the right so the

fuel cap is up. This will help prevent fuel leakage, motor oil seeping

into the air filter, and hard starting.

3. Use a 14 mm (6 point) socket wrench and remove the two blade

bolts [1] and special washers [2] from the blade control assembly

[5]. Use a wooden block to prevent the blades from turning when

removing the bolts.

4. Remove the upper [4] and lower blades [3].

Blade Installation

1. Clean dirt and grass from around the blade mounting area.

2. Install the blades [3] and [4] using the two blade bolts [1] and

special washers [2] as shown.

Be sure to install the special washers with the concave side toward

the blades and the convex side toward the head of the bolt.

The blade bolts are specially designed for this application and

must not be replaced with other bolts.

3. Tighten the blade bolts with a torque wrench [7]. Use a wooden

block [6] to prevent the blades from turning.

Blade bolt torque: 49 ~ 59 N·m

If you do not have a torque wrench, have an authorized Honda

dealer tighten the blade bolts before you use the mower. If the

blade bolts are overtightened, they could break. If the blade bolts

are not tightened enough, they could loosen or come out. In either

case, it would be possible for the blades to fly off while you are

operating the mower.

GRASS BAG CLEANING AND REPLACEMENT

Cleaning

Wash the bag with a garden hose, and allow it to dry completely

before use; a wet bag will clog quickly.

Replacement

Replace a worn or damaged bag with a Honda replacement bag or its

equivalent.

Removal

1. Unclip the plastic

edges [1] of the

bag [2] from the

frame [3].

2. Remove the bag

from the frame.

Installation

1. Insert the bag frame [3] into the bag

[2], as shown above.

2. Clip the plastic edges [1] of the bag

onto the frame.

CHARGING THE BATTERY (HZEA TYPE)

The lawn mower does not have an internal charging system. A plug-in

charger is provided to recharge the battery. Use the plug-in charger

after prolonged storage or anytime you notice a decrease in starter

motor speed.

To assure maximum reliability, the battery should be recharged (boost

charged) before prolonged storage and charged again at the

beginning of the mowing season. Charge the battery in a dry,

well-ventilated area where the temperature is moderate.

Battery posts, terminals and related accessories contain lead and

lead compounds. Wash hands after handling.

 WARNING

Operating this mower with only one blade will result in an

improperly seated blade that can be thrown from the

mower and seriously hurt or kill someone.

Always use both blades as a set.

[1]

[2]

[3]

[4]

[5]

[3] [4]

[1]

[2]

[7]

[6]

 WARNING

A battery can explode if you do not follow the correct

procedure, seriously injuring anyone nearby.

Keep all sparks, open flames, and smoking materials

away from the battery.

[1]

[2]

[3]

[1]

HYEHZE bk1.book Page 16 Monday, September 8, 2008 9:46 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda HRX537 HYEA Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda HRX537 HYEA

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info