Bedienungsanleitung Honda HRX537 HYEA (Seite 17 von 23) (Englisch)

580898

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

ENGLISH

1. Remove the battery cover [1] by depressing the tabs [2] located on

the sides and releasing the tab on top of the battery cover.

2. Disconnect the battery connector [3] by depressing the connector

tab [4] and pulling the battery connector from the harness

connector [5], which is located inside the battery case, above the

battery.

3. Connect the battery connector [3] to the charger [6] supplied with

the mower.

NOTICE

Do not attempt to charge the battery with any charger other than

the one supplied with the mower. Use of a charger other than the

one supplied may result in damage to the electrical system or fire.

4. Plug the charger into a standard household power outlet and let

the battery charge for 20 to 24 hours. The charger may become

slightly warm during charging. This is normal.

NOTICE

Do not charge the battery for more than 24 hours or the battery

may be damaged. Disconnect the battery charger from the battery

before storing the lawn mower.

5. After the battery has charged, disconnect the charger and

reconnect the battery connector to the harness connector.

6. Replace the battery cover. Do not operate without the battery

cover installed.

REPLACING THE FUSE (HZEA TYPE)

The electric starter circuit and battery are protected by a 40 ampere

fuse. If the fuse burns out, the electric starter will not operate. The

engine can be started manually if the fuse burns out.

1. Remove the battery cover by depressing the tabs located on the

sides and releasing the tab on top of the battery cover (page 16).

2. Locate the fuse case [1] above the battery.

3. Remove and inspect the fuse [2]. If it is burned out [3], install the

spare fuse [4] provided with the mower as shown.

NOTICE

Never use a fuse with a rating other than 40 amperes. Serious

damage to the electrical system or a fire can result.

If a frequent fuse failure occurs, it usually indicates a short circuit or

an overload in the electrical system. Take the mower to an authorized

Honda servicing dealer for repair.

TRANSPORTING/STORAGE

TRANSPORTING

Before Loading

If the engine has been running, allow it to cool for at least 15 minutes

before loading the mower on the transport vehicle. A hot engine and

exhaust system can burn you and can ignite some materials.

Turn the fuel valve to the OFF position. This will prevent carburetor

flooding and reduce the possibility of fuel leakage.

Handlebar Folding

1. Remove the grass

bag. You can place it

on top of the engine,

with the bag opening

to the front.

2. Turn the handlebar

adjust knobs [1] 90°

into the unlock

position.

3. Fold handlebar [2]

over mower.

When folding the

handlebar, be careful to avoid kinking or pinching the control

cables.

[2]

[1]

[3]

[5]

[4]

[6]

[3]

[5]

[4]

[1]

[2]

[3]

OFF

[1]

[2]

HYEHZE bk1.book Page 17 Monday, September 8, 2008 9:46 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda HRX537 HYEA Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda HRX537 HYEA

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info